Read Panasonic BM-ET300 / BM-ET300E Service Manual online
– 2-3 –
2-4 Remove the two screws that fasten the camera assem-
bly, and take it off the front of the camera.
Fig. 4
Fig. 5
2-5 Remove the right and left plain bearings from the camera
assembly. Remove the four screws that fasten the cam-
era rear cover, and take the camera rear cover off the
camera assembly.
era rear cover, and take the camera rear cover off the
camera assembly.
Fig. 6
Fig. 7
2-6 Disconnect the two flexible cables connected the CCD
assembly from the camera relay board assembly (CN1,
CN2).
CN2).
2-7 Disconnect the two wires connected to the LED assem-
bly from the camera relay board assembly (CN6, CN7).
2-8 Disconnect the wire connected to the position sensor
from the camera relay board assembly (CN4).
Disconnect the flexible cable connected to the indicator
board assembly from the camera relay board assembly
(CN3).
Disconnect the flexible cable connected to the indicator
board assembly from the camera relay board assembly
(CN3).
Fig. 8
2-9 Remove the four screws that fasten the camera relay
board assembly, and take it off the camera chassis
assembly.
assembly.
Fig. 9
2-10 Remove the two screws that fasten the position sensor
and replace the position sensor.
Fig. 10
Camera Assy
Screw
Slide Bearing
Camera Rear Cover
Flexible Cable of Indicator
Board Assy
Board Assy
Flexible Cable of CCD Assy
Camera Relay Board Assy
Wiring of LED Assy
Wiring of LED Assy
Wiring of Position Sensor
Screw
Camera Relay Board Assy
Screw
Position Sensor
Screw
Screw
Click on the first or last page to see other BM-ET300 / BM-ET300E service manuals if exist.