BM-ET300, BM-ET300E - Panasonic Video Monitoring Service Manual (repair manual). Page 7

y

Alarm output1 (power status)
This terminal is closed and low when power is supplied
from an external power-supply device to the iris camera.
The terminal is opened when the power supply is shut
down.

u

Alarm output2 (tamper detection)
This terminal is activated when the iris camera enters
the "tamper detection" mode by the front/rear tamper
detection switch (activated until the "tamper detection"
mode is cancelled).

i

GND
This is the common terminal for the alarm output con-
nectors.

o

Power input terminals
12 V DC (+12 V at the left/GND at the right) or 24 V AC

– 1-3 –

q

@1

w
e
r
t
y
u
i
o

!0

!6
!7
!8
!9
@0

!1
!2
!3
!4
!5

Not in use

Note: Do not connect any cables

to connectors "Not in use".
It may cause malfunction.

Not in use

Not in use

Pin No.

8 Connection terminal

Q

Wiegand power (card reader)
Supplies power to a card reader.

W

Wiegand GND (card reader)
This is the ground terminal for the power supply and
communication between the iris camera and a card
reader.

E

Wiegand DATA0 (card reader)
A signal (DATA0) is input from a card reader to this ter-
minal.

R

Wiegand DATA1 (card reader)
A signal (DATA1) is input from a card reader to this ter-
minal.

Y

Wiegand power (access control panel)
The iris camera works even when nothing is connected
to this terminal.

U

Wiegand GND (access control panel)
This is the ground terminal for communication between
the iris camera and an access control panel.

I

Wiegand DATA0 (access control panel)
A signal (DATA0) is output from this terminal to an
access control panel.

O

Wiegand DATA1 (access control panel)
A signal (DATA1) is output from this terminal to an
access control panel.

r

Recognition result output1 (ACCEPT)
This terminal is activated when recognition is successful-
ly completed.

t

Recognition result output2 (REJECT)
This terminal is activated when recognition is not suc-
cessfully completed.