Read Panasonic BM-ET300 / BM-ET300E Service Manual online
– 2-2 –
ADJUSTMENT PROCEDURES
Caution: Be sure to shut down the power supply before
detaching the front cover from the iris camera. If the
power is being supplied when the front cover is
detached, the iris camera will enter the "tamper detec-
tion" mode and the buzzer will beep. In case the power
supply cannot be shut down, detach the front cover from
the camera and cancel the "tamper detection" mode by
moving Setup Switch 3 to ON. The buzzer sound will be
stopped. Then fix the temper detection switch in a
pressed state using a tape or the like.
power is being supplied when the front cover is
detached, the iris camera will enter the "tamper detec-
tion" mode and the buzzer will beep. In case the power
supply cannot be shut down, detach the front cover from
the camera and cancel the "tamper detection" mode by
moving Setup Switch 3 to ON. The buzzer sound will be
stopped. Then fix the temper detection switch in a
pressed state using a tape or the like.
Setup Switch Setting for Setup
Before starting the setup, move Setup Switch 3 to ON to can-
cel the "tamper detection" mode. (Set all the other switches
to OFF.)
cel the "tamper detection" mode. (Set all the other switches
to OFF.)
Installation of the Setup Software and
Setup Procedure
Setup Procedure
You will connect the iris camera and setup PC with the setup
cable supplied to the administration software, and carry out
the setup using the setup software installed from the CD-
ROM into the setup PC.
cable supplied to the administration software, and carry out
the setup using the setup software installed from the CD-
ROM into the setup PC.
Platform
To install the setup software, the PC should meet the follow-
ing requirements.
IBM PC or 100 % compatible / Pentium
ing requirements.
IBM PC or 100 % compatible / Pentium
®
300 MHz or higher /
128 MB RAM / 2 MB hard drive space
In addition, the setup PC must be equipped with a CD-ROM
drive and a D-sub 9 pin serial port.
In addition, the setup PC must be equipped with a CD-ROM
drive and a D-sub 9 pin serial port.
• Operating system requirement
Microsoft
®
Windows
®
2000 Professional or
Microsoft
®
Windows
®
XP Professional
• Video display setting requirement
800 x 600 resolution
1. Test Equipment Required
The following Test Equipments are required for Adjustment
of the Iris Camera BM-ET300/BM-ET300E.
of the Iris Camera BM-ET300/BM-ET300E.
• 12 V DC/24 V AC Power Supply Unit
• Personal Computer
• White Paper
• LAN Cross Cable
• Exclusive Setup Cable (Accessory for BM-ET300E)
• ET300 Test Tool
• Personal Computer
• White Paper
• LAN Cross Cable
• Exclusive Setup Cable (Accessory for BM-ET300E)
• ET300 Test Tool
2. Position Sensor Replacement Procedure
2-1 Remove the four screws that fasten the iris camera rear
panel, then take the rear panel off the iris camera.
Fig. 1
2-2 Remove the flexible cable of the camera assembly from
the main board assembly (CN7).
Fig. 2
2-3 Remove the four screws that fasten the damper assem-
blies, and take the right and left damper assemblies.
Fig. 3
Screw
Rear Panel
Flexible Cable
Main Board Assy
Screw
Damper Assy
Damper Assy
ON (Upper side)
1 2 3 4
Click on the first or last page to see other BM-ET300 / BM-ET300E service manuals if exist.