BM-ET300, BM-ET300E - Panasonic Video Monitoring Service Manual (repair manual). Page 12

3-14 Change the positions of the DIP switches on the iris

camera as shown in Fig. 15.

* The wrong switch setting may prevent the iris camera

from booting properly.

3-15 Install the administration software BM-ES300 on the

computer.

Personal computer
The administration software BM-ES300 must have been
installed, and [IrisMngSrv] set ready for start.

How to check
<<Windows XP>>

1. Open the control panel on the computer screen.
2. Select the management tool on the control panel.
3. Select [Service] from the management tools.
4. Check that [IrisMngSrv] of the selected service has start-

ed.

Note: This position sensor adjustment is required in the

following cases;
1. Replacing the Position Sensor
2. Replacing the Main Board

5-1 Turn on the power.  (It takes about a minute to start.)

5-2 Double-click [IrisCmrAdjustKno.exe] that was expanded

in Step 3-1.
The camera setting tool screen shown in Fig. 16 appears
on the monitor.

– 2-5 –

5-3 Press the [Environment Settings] button e on the adjust-

ing tool screen.  The environment setting screen shown
in Fig. 17 appears on the monitor.

5-4 Enter the camera ID and IP address that were set in the

iris camera and confirmed in Step 3-10 in the boxes q
and w on the environment setting screen.

5-5 Confirm that the check mark has been removed from

[Output result file] e on the environment setting screen,
and press the [Apply] button u.

5-6 Press the [Manual Execute] button q on the adjusting

tool screen shown in Fig. 16.

5-7 The manual execution screen shown in Fig. 19 appears

on the monitor.

ON

1

2

3

4

q

r

t

y

w

e

w

y

i

e
t

u

q

e

q
w
r

y

r

t

u