Read JBL SUB 250P (serv.man2) EMC - CB Certificate online
Page 47 of 57
Report No.: 11034065 001
IEC 60065 ATTACHMENT
Clause
Requirement + Test
Result - Remark
Verdict
Article 400 of the National Electrical Code
Table 18 - Upper current limit in column 1
increased from 16 to 30 A and "AWG" wire sizes
used
increased from 16 to 30 A and "AWG" wire sizes
used
N/A
16.3
c) Flexible cords not complying with 16.1, used as
connection between the apparatus and other
apparatus are marked VW-1
connection between the apparatus and other
apparatus are marked VW-1
N/A
16.5
When polymeric materials are involved, strain and
twist testing is to be conducted before and after
the sub-clause 12.1.5 stress relief test.
twist testing is to be conducted before and after
the sub-clause 12.1.5 stress relief test.
N/A
17.8
Expanded to include all cart/stand parts supplied
by the manufacturer, such as casters and
brackets. Suitable assembly instructions are
required.
by the manufacturer, such as casters and
brackets. Suitable assembly instructions are
required.
N/A
17.8
Relevant fixing means are not required when
installation is to be done by a skilled person
installation is to be done by a skilled person
N/A
17.10
Termination of aluminum conductors used as
internal wiring
internal wiring
N/A
17.11
An accessory was investigated to determine that:
a) The accessory, and the combination of the
accessory and the apparatus presents no hazard
in the sense of this standard, and
accessory and the apparatus presents no hazard
in the sense of this standard, and
b) The accessory is provided with installation
instructions.
instructions.
N/A
17.11.1
Installation of an accessory by a skilled person:
a) The mechanical positioning is accomplished by
means of tools normally available or by means of
special tools provided as part of the installation kit,
means of tools normally available or by means of
special tools provided as part of the installation kit,
b) The electrical connections are made by using
existing terminals and connections in the
apparatus or the building wiring
existing terminals and connections in the
apparatus or the building wiring
N/A
18
Non-intrinsically protected picture tubes shall
comply with 18.1, 18.2.2 and 18.3. Intrinsically
protected picture tubes with a maximum face
dimension exceeding 7.5 cm shall comply with UL
61965.
comply with 18.1, 18.2.2 and 18.3. Intrinsically
protected picture tubes with a maximum face
dimension exceeding 7.5 cm shall comply with UL
61965.
N/A
Enclosure opening dimensions
N/A
18.1
All tubes are mounted such that the enclosure of
the apparatus protects the tube against the effects
of implosion.
the apparatus protects the tube against the effects
of implosion.
N/A
Reference to IEC 61965 replaced by UL 61965
N/A
19
The tests in 19.1, 19.2 and 19.3 do not cause the
apparatus to overturn.
apparatus to overturn.
N/A
The test in 19.2.1 does not cause the apparatus to
slide
slide
N/A
When polymeric materials are involved, testing is
N/A
Click on the first or last page to see other SUB 250P (serv.man2) service manuals if exist.