Read JBL ON STAGE III IIIP (serv.man2) EMC - CB Certificate online
<12014238 001 >
Page 31 of 77
IEC 60950-1 / EN 60950-1
Clause
Requirement – Test
Result – Remark
Verdict
TRF No.:IECEN60950_1B
TRF originator: SGS Fimko
the manufacturer or importer.
c) A licence in accordance with Cl. 1 is also not
required by persons who operate an X-ray
emission source on which the electron
acceleration voltage exceeds 20 kV if
required by persons who operate an X-ray
emission source on which the electron
acceleration voltage exceeds 20 kV if
1) the X-ray emission source has been granted a
type approval and
2) it is adequately indicated on the X-ray emission
source that
i) X-rays are generated
ii) the device stipulated by the manufacturer or
importer guarantees that the maximum
permissible local dose rate in accordance
with the type approval is not exceeded and
permissible local dose rate in accordance
with the type approval is not exceeded and
iii) the electron acceleration voltage must not
exceed the maximum value stipulated by the
manufacturer or importer.
manufacturer or importer.
d) Furthermore, a licence in accordance with
Cl. 1 is also not required by persons who operate
X-ray emission sources on which the electron
acceleration voltage does not exceed 30 kV if
Cl. 1 is also not required by persons who operate
X-ray emission sources on which the electron
acceleration voltage does not exceed 30 kV if
1) the X-rays are generated only by intrinsically
safe CRTs complying with Enclosure III, No. 6,
2) the values stipulated in accordance with
Enclosure III, No. 6.2 are limited by technical
measures and specified in the device and
measures and specified in the device and
3) it is adequately indicated on the X-ray emission
source that the X-rays generated are ade-
quately screened by the intrinsically safe CRT.
quately screened by the intrinsically safe CRT.
2.2.4
S (NO): Requirements according to this annex,
1.7.2 and 6.1.2.1 apply.
1.7.2 and 6.1.2.1 apply.
Not TNV
N/A
2.3.2
S (NO): Requirements according to this annex,
6.1.2.1 apply.
6.1.2.1 apply.
Not TNV
N/A
2.3.3 and
2.3.4
2.3.4
S (NO): Requirements according to this annex,
1.7.2 and 6.1.2.1 apply.
1.7.2 and 6.1.2.1 apply.
Not TNV
N/A
2.6.3.3
S (GB): The current rating of the circuit shall be
taken as 13 A, not 16 A.
taken as 13 A, not 16 A.
Class II equipment
N/A
2.7.1
C: Replace the subclause as follows:
Basic requirements
To protect against excessive current, short-
circuits and earth faults in
circuits and earth faults in
PRIMARY CIRCUITS
,
protective devices shall be included either as
integral parts of the equipment or as parts of the
building installation, subject to the following, a), b)
and c):
integral parts of the equipment or as parts of the
building installation, subject to the following, a), b)
and c):
a) except as detailed in b) and c), protective
devices necessary to comply with the
requirements of 5.3 shall be included as parts of
the equipment;
devices necessary to comply with the
requirements of 5.3 shall be included as parts of
the equipment;
Replaced.
P
Click on the first or last page to see other ON STAGE III IIIP (serv.man2) service manuals if exist.