Read JBL ON BEAT MICRO (serv.man3) EMC - CB Certificate online
Issue Date:
2012-10-23
Page 29 of 41
Report Reference #
E204594-A37-CB-1
IEC 60950-1:2005
SubClause Difference + Test
Result - Remark
Verdict
This report issued under the responsibility of UL
2.3.1.b
Limits for measurements across 5000 ohm
resistor in the event of a single fault are replaced
after 200 ms with the limits of M.3.1.4.
N/A
2.3.2.1
In the event of a single fault, the limits of
2.2.3 apply to SELV circuits and accessible
conductive parts.
N/A
2.3.2.4
Enamel coating on signal transformer
winding wire allowed as an alternative to Basic
insulation in specific telecommunication
applications when subjected to special construction
requirements and routine testing.
N/A
2.5
Overcurrent protection device required for
Class 2 and Class 3 limiting in accordance with the
NEC, or for a Limited Power Source, not
interchangeable with devices of higher ratings if
operator replaceable.
N/A
2.6
Equipment having receptacles for output
a.c. power connectors generated from an internal
separately derived source have the earthed
(grounded) circuit conductor suitably bonded to
earth.
N/A
2.6.3.3
For PLUGGABLE EQUIPMENT TYPE A, if
a) b) or c) are not applicable, the current rating of
the circuit is taken as 20 A
N/A
2.6.3.3
The first column on Table 2D requirement:
“Smaller of the RATED CURRENT of the
equipment or the PROTECTIVE CURRENT
RATING of the circuit under consideration."
N/A
2.6.3.4
Capacity of connection between earthing
terminal and parts required to be earthed subject to
N/A
Click on the first or last page to see other ON BEAT MICRO (serv.man3) service manuals if exist.