Read Harman Kardon TU 970II (serv.man4) EMC - CB Certificate online
Page 10 of 24
Report Reference No.: CPSA0106916
Clause
Requirement – Test
Result - Remark
Verdict
Test Report EN 60065E Rev. 00 / 2004-09
a) Resistors between hazardous live parts and
accessible metal parts
accessible metal parts
No such resistors
N
b) Resistors, other than between hazardous live
parts and accessible parts
parts and accessible parts
N
b) Resistors separately approved ........................... : No
N
14.2
Capacitors and RC units
P
Capacitors separately approved
Yes
P
14.2.1
Y capacitors tested to IEC 60384-14, 2
nd
edition ... : Not used Y-capacitors
N
14.2.2
X capacitors tested to IEC 60384-14, 2
nd
edition ... : C900
(see appended table 14)
P
14.2.3
Capacitors operating at mains frequency but not
connected to the mains: tests for X2 ...................... :
connected to the mains: tests for X2 ...................... :
No N
14.2.5
Capacitors with volume exceeding 1750 mm³,
where short-circuit current exceeds 0,2 A:
compliance with IEC60384-1, 4.38 category B or
better ....................................................................... :
where short-circuit current exceeds 0,2 A:
compliance with IEC60384-1, 4.38 category B or
better ....................................................................... :
N
Capacitors with volume exceeding 1750 mm³,
mounted closer to a potential ignition source than
table 5 permits: compliance with IEC 60 384-1,
4.38 category B or better ........................................ :
mounted closer to a potential ignition source than
table 5 permits: compliance with IEC 60 384-1,
4.38 category B or better ........................................ :
N
Shielded by a barrier to V-0 or metal ...................... : Metal chassis
P
14.3
Inductors and windings
⎯
Comply with IEC 61558-1, IEC 61558-2
(as relevant) and clause 20.1.4
(as relevant) and clause 20.1.4
N
14.3.1
Transformers and inductors marked with
manufacturer's name and type ............................... :
manufacturer's name and type ............................... :
Manufacturer’s Identification:
SET
Type: CLT5M026YE/
KLT5M026YE
KLT5M026YE
P
Transformers and inductors separately approved . : No. Tested in apparatus
N
14.3.2 General
Isolation
transformer
P
14.3.3 Constructional
requirements
⎯
14.3.3.1
Clearances and creepage distances comply with
clause 13
clause 13
Complied with the
requirements of clause 13
requirements of clause 13
P
14.3.3.2
Transformers meet the constructional
requirements
requirements
Complied P
14.3.4.1
Class II transformers have adequate separation
between hazardous live parts and accessible parts
(double or reinforced insulation)
between hazardous live parts and accessible parts
(double or reinforced insulation)
Reinforced insulation
P
Coil formers and partition walls > 0,4 mm
P
14.3.4.2
Class I transformers, with basic insulation and
protective screening only if all 7 conditions of
14.3.4.2 are met
protective screening only if all 7 conditions of
14.3.4.2 are met
No such transformer used
Windings of class II
construction
Windings of class II
construction
N
Click on the first or last page to see other TU 970II (serv.man4) service manuals if exist.