KV-SZ252M50 (serv.man3) - Sony TV Service Manual (repair manual). Page 11

– 10 –

Note: Dress while chassis is halfway docked into beznet.

CAUTION:
Prevent tie, cable from touching rear cover or any 
enclosures by turning them away from it --> avoid 
rattle sound. Also prevent tie, cable's end from  
touching solder side of board.

CAUTION:
Prevent tie, cable from touching rear cover or any 
enclosures by turning them away from it --> avoid 
rattle sound. Also prevent tie, cable's end from  
touching solder side of board.

i) Dress Conn Assy, 6P and Conn Assy, 4P VM using tie,
cable at alignment hole 'B' on CV board as shown.
ii) Dress Conn Assy, 4P 200V; Conn Assy, 6P; Conn Assy,
4P VM; Lead Assy, G2 and Lead Assy, Focus with purse
lock Ø 5.

  

Lead Assy, Earth

Conn Assy, 5P Front In

Heatsink A010

Tie, cable at alignment hole 'B'

Conn Assy, 6P

Conn Assy, 4P VM

Conn Assy, 4P VM

Conn Assy, 4P 200V

Conn Assy, 6P

Lead Assy, Focus

Lead Assy, G2

Conn Assy, 4P 200V

Lead Assy, G2

Lead Assy, Focus

Pin, wire A707

Purse lock Ø 5

Purse lock Ø 5

Purse lock Ø 5

Lead Assy, Speaker is not dressed 

together with purse lock. Keep Lead Assy,  

Speaker away from heatsink A010 by

dressing it close to the CRT

Make a 'S' shaped loop on 

Conn Assy, 5P Front In 

and dress together with  

Lead Assy, Earth using 

purse lock Ø 5

Conn Assy,  
5P Front In

Lead Assy, Earth

i) Dress Conn Assy, 7P RGB; Conn Assy, 5P Front In and
Lead Assy, Earth using purse lock Ø 9. Keep wires away from 
heatsinks and high-temperature parts. 

Lead Assy, Earth is behind

Conn Assy, 7P RGB

Purse lock Ø 9

Conn Assy, 7P RGB

Conn Assy, 5P Front In

CN004

Make loop of Conn Assy, 7P RGB as large as 

possible when dressing with purse lock

Lead Assy, Earth

Purse lock Ø 9

Conn Assy, 7P RGB

Lead Assy, Earth

Conn Assy, 5P Front In

Keep Conn Assy, 5P Front In wire in an upward
path from CN9201 to where it is dressed with 
purse lock Ø 9. This is to keep it away from 
deflection area.