Read Sony KV-SK29M80 Service Manual online
– 12 –
KV-SK29M80/H
RM-GA002
2-15. Dress Lead Assy, Speaker to Rotation Coil using purse lock Ø 9
2-16. Dressing of PF board conn assy
(for models with PF board only)
2-17. Cap Assy, High Voltage installation
DY
D604
A007
90
°
Rotation
>5m
Keep distance
of 1mm/kV
Keep distance of
0.5mm/kV
Earth Assy,
Coating wire
Earth Assy, Coating
wire is above
Lead Assy, Speaker
Figure (a)
Dress Lead Assy, Speaker
to center position of Rotation
Coil using purse lock Ø 9
Rotation coil
Lead
Assy, Speaker
Lead Assy, Speaker goes
behind DGC
Pull wire to
the right
Figure(b)
Rotation Coil
Lead Assy, Speaker
(RED+BLK)
Purse
lock Ø 9
PP tape of DGC
Figure(c)
DGC Connector
Pull wire to left
Dress DGC conn wire
behind PP tape and DGC
before inserting to plug
Dress Lead Assy,
Speaker directly on to
DGC using purse lock Ø 11
Lead Assy,
Speaker goes
behind
Rotation Coil
Lead Assy, Speaker
Attach purse lock Ø 9 here
Connector Assy,
3P VH
DGC Connector is below Conn
Assy, 3P VH
to keep Conn Assy, 3P VH away
from Heat Sink A007 and D604
CN605
DGC Band
Dress Lead Assy, Speaker to center position of Rotation coil Make sure Earth assy,
Coating wire is above Lead Assy, Speaker This is to keep Lead Assy, Speaker away from Deflection Yoke.
Coating wire is above Lead Assy, Speaker This is to keep Lead Assy, Speaker away from Deflection Yoke.
Keep wires away from
heatsinks A007, D604 and
conductive parts
TVSR Requirement:
1. Keep HV cable away from conductive parts (distance of
1mm/kV).
2. Keep spacing between edge of anode cap & conductive parts
(distance of 0.5mm/kV).
3. Keep spacing between edge of anode cap & non-conductive
parts (distance of at least 5mm or more).
1. Keep HV cable away from conductive parts (distance of
1mm/kV).
2. Keep spacing between edge of anode cap & conductive parts
(distance of 0.5mm/kV).
3. Keep spacing between edge of anode cap & non-conductive
parts (distance of at least 5mm or more).
DG
HV
Click on the first or last page to see other KV-SK29M80 service manuals if exist.