KV-HV212M50 - Sony TV Service Manual (repair manual). Page 9

– 8 –

CAUTION :
1.  Do not overpull the wires during dressing

--> avoid disconnection of wires.

2.  Make sure wires are kept away from

sharp edges, heatsinks & other
high-temperature parts.

3. Prevent tie, cable from touching rear cover

or any enclosures by turning them away
from it
--> avoid rattle sound. Also prevent tie,
cable's end from touching solder side of
board.

Dress UL Wire (1-923-082-52) as shown:

Note: Ensure UL wire does not touch high temperature 
 resistors 

R828, 

R829 

& 

R889

W068

W069

R828

R829

R889

Ensure UL wire does not touch high
temperature resistors R828, R829 & R889

UL wire

P/N 1-923-082-52

Dress & control mounted wires on C boards if necessary :
--> ensure wires do not get trapped during solder dip process
--> ensure wires do not get punched by ICT jig. (modify ICT 
jig if applicable)

Dress Conn Assy, 7P (RGB) with Cable Tie at alignment hole, 
A as shown.

Make sure Conn Assy, 7P (RGB) does 
not direct contact with heat sink of IC751

Conn Assy,
7P (RGB)

Cable Tie, A

HV Cap 
Assy

TVSR Requirement :
All Connectors must be 
kept away from FBT 
area by a minimum 
distance of 10mm

Lead Assy,
Focus

FBT

Flange

FBT

Flange

Make sure rubber cap 
is pushed down to make 
sure it covers the FBT 
flange completely