Read Sony KV-HV212M50 Service Manual online
– 9 –
KV-HV212M50/M53
RM-GA002
2-5. Conn Assy, 5P (YUV) & Lead Assy, Jumper Dressing
2-6. AC Power Cord, Lead Assy, Earth, Lead Assy & Speaker Dressing
1) Dress Conn Assy, 5P (YUV) & Lead Assy, Jumper with Pin, Wire A021 as shown.
2) Dress Lead Assy, Jumper according to the route shown below:
2) Dress Lead Assy, Jumper according to the route shown below:
Note : Ensure Lead Assy, Jumper is dress away from shield case in the boxed area below:
Ensure Lead Assy, Jumper is dress below Conn Assy, 5P (YUV).
Ensure Lead Assy, Jumper is dress below Conn Assy, 5P (YUV).
R121
Lead Assy, Jumper
Pin, Wire A021
Make sure Conn Assy, 5P
does not touch resistor, R121
does not touch resistor, R121
Make sure the Connector Assy,
5P (YUV) is press down towards
the board.
5P (YUV) is press down towards
the board.
Shield case
NG
OK
Shield case
CAUTION :
1) Dress Lead Assy, Jumper according to the route shown above.
1) Dress Lead Assy, Jumper according to the route shown above.
=> Ensure Lead Assy, Jumper is dress away from shield case in the boxed area.
=> Ensure Lead Assy, Jumper is dress below Conn Assy, 5P (YUV).
Non 3D Models
RY600
Dress AC Power Cord and
Lead Assy, Speaker
(WHT+BLK) with Pin,
Wire A016
Dress AC Power Cord with
Standing Purse Lock,
followed by Lead Assy,
Earth and Lead Assy,
Speaker (RED+BLK).
Standing Purse Lock,
followed by Lead Assy,
Earth and Lead Assy,
Speaker (RED+BLK).
Dress AC Power Cord and Lead
Assy, Speaker (WHT+BLK) with
Pin, Wire A016
Keep wires above of RY600
--> prevent wires from being sandwiched
with front jack & pushed against relay
--> prevent wires from being sandwiched
with front jack & pushed against relay
RY600
Keep Conn. Assy, 3P
above bunch of wires
above bunch of wires
Dress AC Power Cord with Standing
Purse Lock, followed by Lead Assy,
Earth and Lead Assy, Speaker
(RED+BLK).
Keep wires above of RY600
--> prevent wires from being
sandwiched with front jack &
pushed against relay
--> prevent wires from being
sandwiched with front jack &
pushed against relay
3D models
AC Cord Holder
540 ± 5 mm
Lead Assy,
Speaker(RED+BLK)
AC Power Cord
Lead Assy, Earth
Standing Purse
Lock
Dress AC Power Cord & Lead
Assy, Speaker (Left) above the
surrounding capacitors to
prevent from touching high-
temp parts.
Assy, Speaker (Left) above the
surrounding capacitors to
prevent from touching high-
temp parts.
Heat Sink,
A004
Make sure the UL tape is positioned
at the sharp edge of shield case to
prevent wire from being scratched
at the sharp edge of shield case to
prevent wire from being scratched
Conn Assy, 5P (YUV)
Conn Assy, 5P (YUV)
Lead Assy, Jumper
Click on the first or last page to see other KV-HV212M50 service manuals if exist.