KV-HP213M83 - Sony TV Service Manual (repair manual). Page 13

– 12 –

Ensure DGC Conn
is in front before
looping around DGC

Black tape

Earth Assy, Coating is in

front of DGC before looping

it once around DGC.

Figure 10(b)

Dress Connector Assy, 7P
with cable tie at alignment
hole A. Make sure end of
cable tie is facing inwards
--> to prevent rattle sound

Earth Assy, Coating

DGC Conn

AC Power Cord

Lead Assy, Earth

done in Chassis 

assy (pg 7)

Standing purse lock

Conn Assy, 3P

Lead Assy, Speaker

Ensure Connectoar Assy, 3P & Lead Assy, 
Speaker is ABOVE of AC power cord & DGC 
connector & LEFT side of Standing Purse Lock

Standing purse lock

Ensure DGC Connector is
kept behind of black tape

Lead Assy, Speaker

DGC 

DGC Conn

Purse lock Ø9

Keep Lead Assy, Speaker & DGC connector:
1) away from sharp edge of spring extension --> to prevent
scratching on wires
2) close to CRT surface --> to prevent from touching nearby parts

Make sure wire does not touch heat
sink or other high temperature parts

DGC Connector

Spring extension

Lead Assy, Speaker

Lead Assy, Speaker is in
front of DGC & black tape

Lead Assy, Speaker is looped

around DGC once before

inserting to speaker tabs

black tape

Lead Assy, Speaker

CAUTION:
Prevent cable tie from touching rear 
cover or any enclosures by turning them 
away from it
--> to avoid rattle sound & prevent cable 
tie from touching solder side of board.