Read Sony KV-HP213M83 Service Manual online
– 8 –
KV-HP213N63,N63/S,M83
RM-GA002
SECTION 2
WIRE DRESSING
2-1. Mount Caution on C board
Lead Assy, G2 & 200V wire on C Board
A
C
CN801
Mounted Wire (DIP)
Plug (A/I)
CAUTION:
Dress & control mounted wires (Lead Assy, G2 & 200V wire) on C board if
necessary :
--> ensure wires do not get trapped during solder dip process
--> ensure wires do not get punched by ICT jig (modify ICT jig if applicable)
Dress & control mounted wires (Lead Assy, G2 & 200V wire) on C board if
necessary :
--> ensure wires do not get trapped during solder dip process
--> ensure wires do not get punched by ICT jig (modify ICT jig if applicable)
CN703:
Ensure Pin 1 is
connected to
orange wire (200V)
Ensure Pin 1 is
connected to
orange wire (200V)
W700:
Board-in Lead
Assy, G2
Board-in Lead
Assy, G2
C Board
Lead Assy, G2
R795/R760
Keep Lead Assy, G2 away
from leg of conductive parts.
from leg of conductive parts.
R781
CAUTION:
Ensure Lead Assy, G2 is kept away from leg of nearby conductive
parts during solder DIP process
--> to ensure insulation of wire does not get melted when touching
leg of part due to heat conduction from solder bath.
Ensure Lead Assy, G2 is kept away from leg of nearby conductive
parts during solder DIP process
--> to ensure insulation of wire does not get melted when touching
leg of part due to heat conduction from solder bath.
2-2. Wiredressing on A board
Lead Assy, Focus
CAUTION:
Make sure wires are kept away from sharp edges,
heatsinks & other high-temperature parts
Make sure wires are kept away from sharp edges,
heatsinks & other high-temperature parts
FBT Flange
HV cable
Make sure rubber cap is
pushed down to make sure
it covers the FBT flange
completely
FBT Flange
Click on the first or last page to see other KV-HP213M83 service manuals if exist.