KV-HG21M85 - Sony TV Service Manual (repair manual). Page 10

– 9 –

1) Pass the Earth Assy. Coating connector behind DGC (bottom)
  (1x) as shown.
2. Pull & Push Earth Coating assy, Conn. (1x) to ensure its locked
  on CV pwb.

Keep and prevent Earth Assy, Coating wires

from touching surface of Deflection Yoke

Check Cap assy High Voltage ID Mark
Insert Cap assy high voltage lead to FBT (A PWB).

INSTALLATION  METHOD (TVSR REQUIREMENT) :
Insert cap assy HV until 'click' sound is heard & 
push (1x) to ensure it is properly inserted
Pull cap assy HV twice to ensure it does not come off
Do not use excessive force
Push down the rubber cap so that it covers the FBT flange
completely & make sure the rubber cap  is not folded.

1) Install CV PWB to CRT neck.
2) Push the CV PWB towards CRT.

Pull up Conn. Assy 7P to give space for G2 jig.

CAUTION:
1. Make sure Earth Assy, Coating, Conn.  is completely locked.
2. Make sure Earth Assy, Coating is not too tight on C pwb.
3. Make sure Earth Assy Coating wire is kept close to CRT  surface & 
    away from heat sink and other high temperature parts
    --> Position between CRT surface and DGC as shown

CN702 (CV PWB)

CN705 (CV PWB)

Rubber Cap

Cap Assy, High Voltage

CAUTION:
Make sure the CRT socket is properly
installed into the CRT neck.

Space Between CV PWB &

Conn. Assy 7P

Conn.7P

CV PWB