Read Sony MPK-DVF6 Service Manual online
– 4 –
MPK-DVF6
12
-GB
Preparations (continued)
1
Remove the grip.
Undo the screw on the bottom side
of the marine pack.
of the marine pack.
2
Insert the lithium battery into the grip.
1 Remove the screw with the
supplied screw driver.
2 Insert the supplied lithium
battery (CR2,
×
1) with the
polarity positioned correctly as
indicated on the grip.
indicated on the grip.
3 Fasten the screw tightly.
3
Unfasten the 3 latches and open
the marine pack.
the marine pack.
If you lift the metal part in the
direction of the finder when the
latches are open, the latches will
stop.
direction of the finder when the
latches are open, the latches will
stop.
Preparing the marine pack (installing the battery)
13
-GB
GB
4
Insert the batteries (optional) into the LCD monitor battery compartment.
Use four AA alkali dry batteries or four Ni-MH batteries.
Use new dry batteries.
If you use rechargeable dry batteries, fully charge it before use.
If you use rechargeable dry batteries, fully charge it before use.
Notes
• Be sure to use four batteries of the same type.
• Be sure to confirm the
• Be sure to use four batteries of the same type.
• Be sure to confirm the
3# poles of the batteries. Inserting the batteries with the
poles in the wrong direction may cause leakage or ruptures.
About the LCD monitor
• Install the camcorder to the marine pack and set the POWER switch to ON to make
images appear on the LCD screen.
• The remaining battery time indicator displayed on the LCD monitor refers to
remaining time of the camcorder battery time, not the remaining time of the LCD
monitor battery.
monitor battery.
continued
14
-GB
Preparations (continued)
Installing the camcorder to the marine pack
For DCR-HC40/HC40E/HC30/HC30E/HC20/HC20E/HC18E/HC16E
1
Install the camcorder to the marine pack.
Connect the remote plug and the
microphone plug.
1 Connect the microphone plug to the
microphone plug.
1 Connect the microphone plug to the
MIC jack (plug in power).
2 Connect the remote plug to the
LANC jack.
2
Insert the camcorder until the
mounting shoe clicks into place.
mounting shoe clicks into place.
3
Connect the monitor cord to the A/V
conversion cable attached to the
camcorder.
conversion cable attached to the
camcorder.
4
Attach the front shell to the rear shell.
Hold both shells firmly and fasten the 3
latches securely.
Hold both shells firmly and fasten the 3
latches securely.
Take care not to pinch the remote,
microphone, and monitor cords. If this
happens water may leak in.
For details on handling the O-ring, see page
29.
Take care not to pinch the cords.
microphone, and monitor cords. If this
happens water may leak in.
For details on handling the O-ring, see page
29.
Take care not to pinch the cords.
The cords are placed in the
plug holders of the marine
pack at the factory. Pull the
plugs out of the holders
when in use.
plug holders of the marine
pack at the factory. Pull the
plugs out of the holders
when in use.
front shell
1 to the MIC jack
(plug in power)
2 to the LANC jack
15
-GB
GB
5
Attach the grip.
Fasten the screw tightly.
Now you have finished the preparations.
Be sure to check that the equipment operates correctly and that there is no water
leakage before you dive (see page 20).
Be sure to check that the equipment operates correctly and that there is no water
leakage before you dive (see page 20).
continued
Click on the first or last page to see other MPK-DVF6 service manuals if exist.