MPK-DVF6 - Sony Movie Service Manual (repair manual). Page 9

MPK-DVF6

• After you have used the marine pack, be sure to perform the following:

– Wash the marine pack with fresh water with the buckle closed to remove salt or

sand.

– Insert the marine pack in fresh water for about 30 minutes with the buckle closed.

If salt is left on the marine pack, metal parts and the O-ring might be damaged, and
cause water leaks.

– When sun oil is stuck to the marine pack, wash off with lukewarm water.

If sun oil is left on the marine pack, the surface of the marine pack might become
discoloured or become damaged.

– Wipe the inside of the marine pack with a soft, dry cloth. Do not wash with water.

• Remove the O-ring each time that you have finished using it, and check it.

If the marine pack is dried with sea water still in the O-ring groove, salt crystals form,
and might impair the O-ring’s functions.

• Do not use thinner, benzene, alcohol or other solvents as they will damage the

surface finish.

• Prevent dust from sticking to O-rings.
• Apply a thin coating of grease to the O-ring, set it in the groove, and store in a well-

ventilated location. Do not close the buckle.

• Avoid storing O-rings in hot, cold or humid locations, and placing in naphthalene or

camphor. These locations and solutions will damage the materials.

• To maintain the O-ring’s functions, avoid storing them in hot locations or in the

direct sunlight.

• Do not place the spare O-ring under heavy objects. Doing so might deform the

O-ring.

Replace the O-ring with a new one after one year of use.
Even if the O-ring is not cracked or scratched, deformation or wear reduces the
waterproof qualities of the O-ring. Replace the O-ring with a new one if cracking, skew,
distortion, fine splitting, scratches, sand-biting, etc. is found.

You can obtain O-rings and grease at your nearest Sony dealer.
O-ring (model No. 3-977-362-01)
Grease (model No. 3-071-370-01)

The metal parts will rust and the movement of the operation switches will be impaired
if you leave salt water on the marine pack. If sea water enters through scratches in the
coating, the salt can corrode the metal parts of the marine pack unit and cause the
coating to peel off. After recording in the sea, submerge the marine pack in tap water or
fresh water for about 30 minutes before undoing the buckles to completely remove any
salt from the marine pack unit, filter, and wide-conversion lens.
After washing, wipe any water from the inside of the marine pack and the loaded video
camcorder with a soft dry cloth.
*  Always follow the above precautions when you use the marine pack.
When you open the marine pack or exchange the battery pack of the grip, take care that
no water drips from your wet suit or hair.
Do not leave the marine pack under direct sunlight for a long period of time, otherwise
the temperature in the marine pack may rise and the equipment inside may be
damaged. If you cannot avoid leaving the marine pack under direct sunlight, be sure to
cover the marine pack with a towel or other protection.

Coat the O-ring slightly with the supplied grease, and put it in the groove correctly.
Join the front and rear shells then put it in a cool and dry place without fastening the
buckles.
Avoid storing the marine pack in a very hot, cold, or humid place, or together with
naphthalene or camphor, as these conditions might damage the unit.

When transporting the marine pack, be sure to remove your camcorder from it.
Otherwise this might damage the unit.

Note
When you use the supplied carrying
bag, attach the supplied carrying belt
and adjust the length of the belt.
Avoid rough handling or a shock. We
recommend covering the marine pack
with a towel or other protection.

B

Remote
control
transmitter

LCD monitor
battery
compartment

Monitor plug

PHOTO button

A/V connecting cable

Spacer C

Battery
check
indicator

Camera mounting shoe D

Screw plate

LCD
monitor

Guide rail

Microphone plug

Cushions for camera
mounting shoe D

Camera
mounting shoe E

Lithium battery
compartment

Grip

AUTO FOCUS
ON/OFF button

Remote plug (blue)

REC lamp (red)
LEAK lamp (yellow)

Video light shoe

Front glass

Underwater
microphone
(monaural)

POWER switch

O-ring

ZOOM buttons

START/STOP
button

A/V conversion cable

A/V connecting cable

Camera mounting
shoe F

Battery adaptor

Belt

Camera
mounting shoe G

Camera mounting shoe B

Remote control
detector