Read Sony HDR-CX530E / HDR-CX535 / HDR-CX610E / HDR-PJ530E / HDR-PJ540 / HDR-PJ540E / HDR-PJ610E (serv.man2) Service Manual online
1-5
HDR-CX530E/CX535/CX610E/PJ530E/PJ540/PJ540E/PJ610E_L2
– ENGLISH –
Projector problem checking procedure (indication on brightness)
Yes
No
OK
NG
OK
NG
OK
NG
A
B
Indicated defective
projector received
Measure brightness.
( 2)
Measure brightness.
( 2)
Indication on
brightness
Inspect projector
LED.
( 1)
1 Refer to the ADJUST tab of Adjust Manual.
2 Refer to the SERVICE tab of Adjust Manual.
2 Refer to the SERVICE tab of Adjust Manual.
END
-
-
-
-
-
-
-
Replace projector unit (light emitting block). (*1)
Replace PJ board. (*1)
Replace both projector unit (light emitting block)
and PJ board. (*1)
Replace PJ board. (*1)
Replace both projector unit (light emitting block)
and PJ board. (*1)
Projector Data Input
Fixed value input
Enter the number on the label attached to the unit.
Serial number input
LD40
Enter the number on the label attached to the unit.
Serial number input
LD40
Syywwnnnnn
Enter the red part.
(See page 1-4)
(See page 1-4)
1-8. FRONT ORNAMENT REPLACING METHOD
Note: A protective Lens Cap is attached to each new service
Lens Block.
Carry out replacement work with this Lens Cap attached.
Lens Cap
Removal
(1) Disconnect the three connectors and peel off the Adhesive Parts
of the Motor A Flexible Board, Motor B Flexible Board, and the
FP-2126 Flexible Board.
FP-2126 Flexible Board.
TOP
FRONT
Adhesive part
Adhesive part
Adhesive part
Connector
Connectors
FP-2125 Flexible
Board
Board
FP-2126 Flexible
Board
Board
Flexible Board of the Motor B
Flexible Board of
the Motor A
the Motor A
(2) Remove the seven screws and remove the Sheet Metal (C) and
the Edge of Mechanical Rubber while detaching the two bosses,
and then peel off the Adhesive Part of the FP-2125 Flexible
Board.
and then peel off the Adhesive Part of the FP-2125 Flexible
Board.
TO
P
FRO
NT
Screws
Screws
Mecha Stopper Rubber
Screw
Screw
Screw
Boss
Boss
Adhesive part
FP-2125
Flexible Board
Flexible Board
Sheet Metal (C)
(3) Peel off the Adhesive Part of the FP-2189 Flexible Board.
TO
P
FRONT
Adhesive part
FP-2189
Flexible Board
Flexible Board
(4) Remove the five screws and remove the Frame (F-SUB-A),
Frame (F-SUB-B), and Ball Bearing while detaching the four
bosses and the shaft.
bosses and the shaft.
TO
P
FRONT
Screw
Screw
Screws
Boss
Boss
Boss
Bosses
Shaft
Motor B
Frame (F-Sub-B),
Ball Bearing
Ball Bearing
Frame (F-Sub-A)
Click on the first or last page to see other HDR-CX530E / HDR-CX535 / HDR-CX610E / HDR-PJ530E / HDR-PJ540 / HDR-PJ540E / HDR-PJ610E (serv.man2) service manuals if exist.