SAL35F18 - Sony Digital Camera Service Manual (repair manual). Page 8

2-5

SAL35F18 (DT 1.8/35 SAM) (DT 35mm F1.8 SAM)

1.  Fold the PC board joint flexible as shown in the illustration.
2.  Affix the PC board joint flexible along the reference.

PC Board Joint Flexible

Reference for affixing

Crest folds

Valley folds

1.  Attach three pieces of interception tape to the ornamental tube, and install the ornamental tube to the main body.

  Align the cutout of the ornamental tube with the projection of the filter screw frame.

Cutout

Cutout

Projection

Projection

Interception Tape

Ornamental Tube

Filter Screw Frame

1.  Set the main unit assembly to the infinity end and insert counterclockwise the helicoids male as far as it goes.
2.  Install the lens unit assy to the main unit assy, aligning the driving wheel pin with the cut portion (working part of driving wheel pin).

 

Insert three projections of rear frame assy in three grooves of vertical group cylinder.

3.  Tighten with three screws.

  Install screws in the center of oblong holes of filter screw frame.

Main Unit Assy

Vertical
groove
Cylinder

Vertical groove

Lens Unit Assy

Projection
(Outer Tube)

Screw

Oblong hole of
Filter Screw Frame

Helicoid Male

Driving wheel pin

Cutout
(Working part of driving wheel pin)