SAL35F18 - Sony Digital Camera Service Manual (repair manual). Page 7

2-4

SAL35F18 (DT 1.8/35 SAM) (DT 35mm F1.8 SAM)

How to remove the switch panel block (Scar prevention)

1.  Remove three screws fixing the rear mirror assy tube.
2.  Set the switch panel block to  AF .
3.  Hold down the middle lens barrel assy and pull up the rear mirror assy tube slightly to the direction of the mount until the indicated 

hole of rear mirror assy tube is seen.

4.  Insert tweezers or a narrow tip stick in the hole of rear mirror assy tube and peel the switch panel block by pushing it from the inside 

with the tweezers or the narrow tip stick.

Rear Mirror Assy Tube

Direction of the Mount

Middle Lens Barrel Assy

Narrow tip stick

Hole

Switch Panel Block

Note on the switch panel block installation

1.  Set the select switch of DC motor (geared) to AF.
2.  Set the knob of switch panel block to AF.
3.  Peel the released paper off the switch panel block and install the switch panel block.

Select switch of
DC Motor (Geared)

Switch Panel Block

Knob

AF Side

MF Side

1.  Install the rear mirror assy tube, aligning the installation hole of switch panel block with the select switch DC motor (geared).
2.  Fix it with three screws.

Installation hole of
Switch Panel Block

Rear Mirror Assy Tube

Select switch of
DC Motor (Geared)

1.  Affix the flexible of DC motor (geared) to the middle lens barrel assy.
2.  Connect the PC board joint flexible to the connector.

PC Board Joint Flexible

DC Motor (Geared)

Middle Lens Barrel Assy

Connector