Read Sony SAL35F18 Service Manual online
2-3
HELP
Note for assembling and grease applying positions are shown.
SAL35F18 (DT 1.8/35 SAM) (DT 35mm F1.8 SAM)
HELP01
How to remove the mount assy
1. Remove four screws.
2. Set the focus to the infinity end.
3. Float the mount.
4. Disconnect the connector of PC board joint flexible.
5. Set the aperture of preset lever to Open and disconnect the linkage of function lever and driving wheel pin.
2. Set the focus to the infinity end.
3. Float the mount.
4. Disconnect the connector of PC board joint flexible.
5. Set the aperture of preset lever to Open and disconnect the linkage of function lever and driving wheel pin.
PC Board Joint Flexible
Mount
Preset Lever
Function Lever
Driving Wheel Pin
How to install the mount assy
1. Set the focus to the infinity end.
2. Set the aperture positions of driving wheel pin and preset lever Open .
3. Link the function lever with the driving wheel pin.
4. Connect the PC board joint flexible.
5. Fix the mount assy with four screws.
2. Set the aperture positions of driving wheel pin and preset lever Open .
3. Link the function lever with the driving wheel pin.
4. Connect the PC board joint flexible.
5. Fix the mount assy with four screws.
PC Board Joint Flexible
Preset Lever
Function Lever
Driving
Wheel Pin
Wheel Pin
Mount
HELP02
How to remove the connection board
1. Remove two stopper screws securing connection board.
2. Push down the inner side of connection board.
3. Remove the Main PC board assy with shifting the outside of connection board to inward.
2. Push down the inner side of connection board.
3. Remove the Main PC board assy with shifting the outside of connection board to inward.
2
3
Connection Board
Main PC Board Assy
Connection Board
1 Stopper Screws Securing
Connection Board
Outside
Inside
How to attach the connection board
1. Push the outside of connection board to outward.
2. Install the Main PC board assy with pushing up the inside of connection board.
3. Tighten two stopper screws securing connection board.
2. Install the Main PC board assy with pushing up the inside of connection board.
3. Tighten two stopper screws securing connection board.
1
2
3 Stopper Screws Securing
Connection Board
Connection Board
Main PC Board Assy
Connection Board
Outside
Inside
HELP03
Grease (G-36): J-6082-667-A
1. Apply the grease (G-36) to the main spring sliding surface of mount.
Note:
Do not spread the grease to the mount inner side.
Note:
Do not apply the grease to the 1mm from edge of wall.
Apply the grease (G-36)
(Main spring sliding surface)
(Main spring sliding surface)
Cross section (Coating portion)
1mm
(Edge of wall)
(Edge of wall)
Do not apply
Grease (G-36)
Mount
Do not spread the grease
to the mount inner side
to the mount inner side
Click on the first or last page to see other SAL35F18 service manuals if exist.