SAL300F28G2 - Sony Digital Camera Service Manual (repair manual). Page 11

2-8

SAL300F28G2 (2.8/300 G SSM 

Ⅱ) (300mm F2.8 G SSM Ⅱ)

Universal wrench: J-6082-609-A
Chip A for universal wrench: J-6082-609-1
Chip B for universal wrench: J-6082-609-2
Adhesive bond (B-10): J-6082-612-A

Tighten the filter holder and apply the adhesive bond (B-10) to the indicated portion.

  When removing or installing, use the universal wrench.

Filter Holder

Filter Holder

Filter

Filter

Front Lens Barrel A

Front Lens Barrel A

Apply the adhesive bond (B-10).
(3 location on the circumference
with 30 mm width.)

Adhesive bond (B-40): J-6082-614-A

1.  Install the rear light shield barrel. Apply two drops of adhesive bond (B-40) to the tips of three screws and tighten the rear light shield 

barrel with three screws.

2.  Install the connection box block. Apply two drops of adhesive bond (B-40) to the tips of two screws and tighten the rear light shield 

barrel with three screws.

Connection Box Block

Rear Light
Shield Barrel

Apply the bond
(B-40)

Apply the bond
(B-40)

Grease (G-85): J-6082-626-A
Adhesive bond (LOCTITE 460)

  Use the adhesive bond (LOCTITE 460) or the equivalent.

 

Do not use the instant glue, which becomes white after dried.

1.  Apply two drops of adhesive bond (LOCTITE 460) to the tip of stopper screw and tighten it to the mount.
2.  Apply the grease (G-85) the indicated portion of mount.

Back side of claw
(3 locations)

Entrance
side

Entrance
side

Entrance
side

Entrance
side

Stopper Screw

Mount

Mount

Approx. 3-5 mm

Inside

Outside

Apply the adhesive bond
(LOCTITE 460)

Apply the grease
(G-85)

Apply the grease
(G-85)

Cut
view

Cut
view