Read Sony SAL18552 Service Manual online
2-1
SAL18552 (DT 3.5-5.6/18-55 SAM Ⅱ) (DT 18-55mm F3.5-5.6 SAM II)
2. DISASSEMBLY
NOTE FOR REPAIR
• Make sure that the flat cable and flexible board are not cracked of bent at the terminal.
Do not insert the cable insufficiently nor crookedly.
• When remove a connector, don t pull at wire of connector. It is possible that a wire is snapped.
• When installing a connector, don t press down at wire of connector.
It is possible that a wire is snapped.
• Do not apply excessive load to the gilded flexible board.
Notches
Holes
How to Use
Universal wrench
J-6082-609-A
J-6082-609-A
Chip-A for
universal wrench:
J-6082-609-1
universal wrench:
J-6082-609-1
Chip-B for
universal wrench:
J-6082-609-2
universal wrench:
J-6082-609-2
Chip-C for
universal wrench:
J-6082-609-3
universal wrench:
J-6082-609-3
Attach the chip-A, chip-B or chip-C to the universal wrench.
For the notches:
For the holes:
For the notches:
For the holes:
UNIVERSAL WRENCH
In case of the following notches or holes are located in the lens block, etc during disassembling/
assembling the lens, Use the universal wrench.
assembling the lens, Use the universal wrench.
chip-A, chip-C
chip-B
chip-B
Notches
Holes
Chip
Chip-A
or
Chip-C
Chip-A
or
Chip-C
Chip-B
Chip-B
Chip
Match the universal wrench to the holes or notches of the lens block, etc.
Match the universal wrench
to the width of holes or notches.
to the width of holes or notches.
Universal wrench
B-10
FT-210
Grease (FT-210): 9-913-200-37
Adhesive bond (B-10): J-6082-612-A
SERVICE TOOLS
SG-310
Grease (SG-310): 9-913-200-36
Cut and remove the part of gilt
which comes off at the point.
(Be careful or some
pieces of gilt may be left inside)
which comes off at the point.
(Be careful or some
pieces of gilt may be left inside)
Click on the first or last page to see other SAL18552 service manuals if exist.