SAL1635Z2 - Sony Digital Camera Service Manual (repair manual). Page 10

2-7

SAL1635Z2 (Vario-Sonnar 2.8/16-35 ZA SSM II) (Vario-Sonnar T* 16-35mm F2.8 ZA SSM II)

Adhesive bond (B-40):  J-6082-614-A
Grease (G-116): 

J-6082-628-A

1.  Apply grease (G-116) to the indicated portion of Outer Barrel Block ASSY.
2.  Set the Optics Block ASSY to the WIDE end.
3.  Install the SSM Flexible Board to the hole A of the Outer Barrel Block ASSY, threading the Focus Brush Base through the oblong hole 

B.

 

Focus Brush Base

Outer Barrel Block ASSY

Outer Barrel Block ASSY

Optical Block ASSY

Oblong Hole B

Set to the WIDE end.

SSM flexible board

Hole A

Apply grease (G-116)
(All circumference)

4.  Apply adhesive bond (B-40) to about two threads from the tips of screws and tighten them (at three locations).

 

Apply adhesive 
bond (B-40).

1.  Clean the sticking position of encoder printed wiring board of outer barrel with ethanol.

 

2.  Peel off the released paper of encoder printed wiring board focus side, affix the encoder printed wiring board aligning at the standard 

positon.
Note:

  Do not run onto a step.

 

Reference to affixing

Outer Barrel

Released Paper

Focus side

3.  Peel off the released paper of the remainder, affix the encoder printed wiring board aligning at the standard position.

 

Released Paper

Reference to affixing

4.  Affix the center portion of encoder printed wiring board.

  If the portion B rises, do not match it with a standard forcibly, affix the encoder printed wiring board without rising.

 

B Part