DSC-TX30 (serv.man2) - Sony Digital Camera Service Manual (repair manual). Page 14

DSC-TX30_L2

1-11

When replacing the lens, read the QR code given on the data sheet of the 
replacement lens for service.
Start the Adjust Manual and read the QR code using a QR code reader.
The read data is used for adjustment after replacement.
Select “Lens data carry” on the ADJUST tab of the Adjust Manual, and 
click the LOAD button to load the file.

QR cord

The data can be copied/erased by the operations on the MENU screen. (When erasing the data, execute formatting the internal memory.)

Note 1:  When replacing the SY-1009 board, erase the data in internal memory of the board before replacement.
Note 2:  When replacing the SY-1009 board, execute formatting and initialize the internal memory after replacement.

Copies all images in the internal memory to a memory card.

1.  Insert a memory card with sufficient free capacity into the camera.
2.  MENU 

 

 (Settings) 

 

 (Memory Card Tool) 

 [Copy] 

 [OK]

Use a fully charged battery pack. If you attempt to copy image files using a battery pack with little
remaining charge, the battery pack may run out, causing copying to fail or possibly corrupting the
data.
Images cannot be copied individually.
The original images in the internal memory are retained even after copying. To delete the contents
of the internal memory, remove the memory card after copying, then format the internal memory
([Format] in [Internal Memory Tool]).
The data will be copied to the recording folder that is currently being used, with a number one
higher than the largest data number in that folder. 

6)  Click the [File Update] button in the window.
 

7)  A file selection screen opens. Select the Destination Data file to be added and click the [Open] button.
 

8)  When the file has been successfully added, the following window opens.
 

9)  Check the Destination Ver. window and confirm that the version has been updated.

Destination Ver. window