DSC-TX30 (serv.man2) - Sony Digital Camera Service Manual (repair manual). Page 16

DSC-TX30_L2

1-13

Self-diagnosis Code

Symptom/State

Correction

Repaired by:

Block

Function

Detailed

Code

C

1

3

0

1

The internal memory has experienced a me-
dia error.

Turn the power off and on again.

The internal memory has experienced a for-
mat error.

Format the internal memory.

Memory card is unformatted.

Format the memory card.

Memory card is broken.

Insert a new memory card.

Memory card type error.

Insert a supported memory card.

The camera cannot read or write data on the 
memory card.

Turn the power off and on again, or taking out and inserting the memory 
card several times.

C

3

2

0

1

Trouble with hardware.

Turn the power off and on again.

E

4

1

 0 

0* Abnormality of network control.

Turn power off and turn power on again.

E

4

1

 0 

1* Abnormality of network control device.

Turn power off and turn power on again.

E

6

1

0

0

Difficult to adjust focus.
(Cannot initialize focus)

Retry turn the power on by the power switch. 

E

6

1

1

0

Zoom operations fault.
(Cannot initialize zoom lens.)

Retry turn the power on by the power switch. 

E

6

1

 3 

0

Reset position detection error on the stepper
iris initializing.

Turn power off and turn power on again.

E

6

2

0

2

Abnormality of IC for steadyshot.

Turn power off and turn power on again.

E

6

2

1

0

Lens initializing failure.

Turn power off and turn power on again.

E

6

2

1

1

Lens overheating (PITCH).

Turn power off and turn power on again.

E

6

2

1

2

Lens overheating (YAW).

Turn power off and turn power on again.

E

6

2

2

0

Abnormality of thermistor.

Turn power off and turn power on again.

E

9

1

0

1

Abnormality when flash is being charged.

Checking of flash unit or replacement of flash unit. (Note 1)

E

9

4

0

0

Internal memory fault.

Turn power off and turn power on again.

E

9

5

 0 

0* GPS hardware error.

Turn power off and turn power on again.

E

9

5

 0 

1*

Acceleration sensor hardware error .
(GPS hardware error)

Turn power off and turn power on again.

E

9

5

 0 

2*

Electronic compass hardware error.
(GPS hardware error)

Turn power off and turn power on again.

Note 1:  After repair, be sure to perform “1-12. PROCESS AFTER FIXING FLASH ERROR”.
Note 2:  Functions of codes with * mark are not provided in this unit.

When “FLASH error” (Self-diagnosis Code E : 91 : 01) occurs, to prevent any abnormal situation caused by high voltage, setting of the flash is changed 
automatically to disabling charge and flash setting.
After fixing, this setting needs to be deactivated. 

Reset Flash Error using the Flash Error Repair Tool Ver_[].[].exe

The changed portions from
Ver. 1.2 are shown in blue.