DSC-G3 (serv.man3) - Sony Digital Camera Service Manual (repair manual). Page 28

6-27

DSC-G3_ADJ

[Automatic Adjustment Program execution items and
sequence]
1. Touch Panel Adj.

[Adjusting method]
1) Click the [Start] button of the Touch Panel Adjustment.
2) The Automatic Adjustment Program executes the “1. Touch

Panel Adj.”. The following message is displayed, and then
adjust the LCD screen in accordance with the instructions given
on the screen.

3) Upon successful completion of all item the Touch Panel Ad-

justment, the following message is displayed. Click the [OK]
button.

In the case of an error during the execution of adjustment, the
Automatic Adjustment Program interrupts the processing at that
point, and displays an error message, and then terminates the pro-
gram execution there.

When an error message is displayed, perform the remedy given
below, and then retry adjustment. If the error message is displayed
though the remedy was performed, the circuits will be faulty.

Symptom

USB communication with the set is abnormal.

Cause

• USB cable is not inserted tightly.

• Power supply is not installed correctly.

• Communication with SeusEX is abnormal.

Remedy

• Disconnect the USB cable once, and then re-

connect it tightly and check that the set is in
“USB Mode”.

• Install the power supply correctly.

• Start the SeusEX and click the [Connect]  to

check that the connection state is established.

Symptom

The camera is not ready for adjustment.

Cause

Data error exists in the camera.

Remedy

Reset the camera.

This part indicates 
the adjustment 
item in which 
an error occurred.

Symptom

Adjustment does not finish within the specified
time.

Cause

• Adjustment conditions are wrong.

• Data error exists in the camera.

Remedy

• Check that the conditions such as a subject

are correct.

• Reset the camera.