DSC-G3 (serv.man3) - Sony Digital Camera Service Manual (repair manual). Page 25

6-24

DSC-G3_ADJ

Preparation:
1) Read the PITCH sensor (SY-211 board SE510) sensitivity writ-

ten on repair parts, and named this as S

502

.

2) Read the YAW sensor (SY-211 board SE510) sensitivity writ-

ten on repair parts, and named this as S

501

.

With the direction mark of the angular velocity sensor located in
the lower left position, read the data value.

Perform this adjustment only when replacing the angular velocity
sensor or lens block. When the microprocessor, circuit etc. is dam-
aged, don’t perform this adjustment but check the operations only.

Before adjustment, read the following data and record them.
When the SY-211 board is replaced, read out the data before the
replacement, and record them.

Reading out method:
1) Read out the data in Block: 11, Page: 61, Address: 0E10, and

name this as Dp.

2) Read out the data in Block: 11, Page: 61, Address: 0E11, and

name this as Dy.

3) Read out the data in Block: 11, Page: 61, Address: 0E07, and

name this as Fpy (Note 2).

The previous data (Dp, Dy and Fpy) can be read from

the SY-211 board and it can be saved in the PC as a
file by using the Automatic Adjustment Program.
(Refer to “10-4. Angular Velocity Sensor Sensitivity
Adjustment”)

If correct data reading failed, replace the lens together

with the SY-211 board.

Note down the sensitivity displayed on the angular velocity sensor of
the repair parts. At this time, note down also to which board it was
attached to.
Be sure to check because if attached incorrectly, the screen will vi-
brate up and down or left and right during the steady shot operations.

There are only one type of a repair parts.

The sensor incorporates a precision oscillator. Handle it with care as
if it dropped, the balance of oscillator will be disrupted and opera-
tions will not be performed properly.

Adjustment Block

11

Adjustment Page

61

Adjustment Address

0E10, 0E11, 0E07

The sensor sensitivity of SE510 of the SY-211 board is writ-
ten only repair parts.

PPP

YYY

SE510

YYY : YAW Sensor sensitivity

S

501

PPP : PITCH Sensor sensitivity

S

502

198

198

Direction Mark

Hand Writing

For the sensor sensitivity value 198