Read Sony XAV-68BT Service Manual online
XAV-68BT
4
NOTE OF REPLACING THE CHASSIS MAIN ASSY (CHA1)
When the chassis MAIN assy (CHA1) is replaced, the destination
setting is necessary.
When the chassis MAIN assy (CHA1) is replaced, the destination
setting is necessary.
Note: Remote commander is necessary.
1. Preparing the Destination Setting
Be sure to solder the SL001 on the MAIN board before doing the
destination setting.
Be sure to solder the SL001 on the MAIN board before doing the
destination setting.
– MAIN Board (Component Side) –
SL001
SL001
2. Destination Setting
Set destination according to the procedure below.
Set destination according to the procedure below.
2-1. Setting the Destination Code
1. In the state of source off (Home screen is displayed), enter
1. In the state of source off (Home screen is displayed), enter
the destination setting mode by pressing the buttons on the
remote commander in order of the [4]
remote commander in order of the [4]
t [5] t [6] (press
only the [6] button for two seconds).
– Continued on next page –
NOTE FOR TRANSPORTATION
When this unit is transported, it is necessary to install two transpor-
tation screws. Please transport it after installing two transportation
screws as shown in the fi gure below.
When this unit is transported, it is necessary to install two transpor-
tation screws. Please transport it after installing two transportation
screws as shown in the fi gure below.
Part No.
Description
A-2018-257-A SCREW WITH WARNING LABEL
WARNING!!!
Warning label
u1
Transportation screw
u2
WARNING!!!
warning label
transportation screw
transportation screw
Click on the first or last page to see other XAV-68BT service manuals if exist.