Read Sony DAV-X1G / HCD-X1G Service Manual online
HCD-X1G
11
Note:
Follow the disassembly procedure in the numerical order given.
3-2. OPTICAL PICK-UP BLOCK (KHM-310CAA OR KHM-313CAA)
•
This set can be disassembled in the order shown below.
3-1. DISASSEMBLY FLOW
SECTION 3
DISASSEMBLY
3-2. OPTICAL PICK-UP BLOCK
(KHM-310CAA OR KHM-313CAA)
(Page 11)
(Page 11)
3-3. SIDE PANEL (L/R)
(Page 12)
3-4. CASE (AL)
(Page 12)
3-5. FRONT PANEL SECTION
(Page 13)
3-6. MAIN BOARD
(Page 14)
3-9. CHUCK CAM, BELT
(Page 16)
3-7. D.C. FAN (M450), BACK PANEL SECTION AND SHEET (MAIN)
(Page 14)
3-8. DVD MECHANISM DECK (CDM85-DVBU102)
(Page 15)
SET
1
two screws
(PTP3
(PTP3
×
8)
6
two
insulator screws
insulator screws
5
two insulator screws
4
two claws
5
Lift up the holder (FFC).
7
Lift up the
optical-pick-up block.
optical-pick-up block.
q;
optical-pick-up block
(KHM-310CAA or KHM-313CAA)
(KHM-310CAA or KHM-313CAA)
2
chassis cover
3
cover (CDM)
Note: The chassis cover and cover (CDM) on the bottom of the set can be removed
when replacing the optical pick-up block KHM-310CAA or KHM-313CAA.
9
Be sure to bridge here, and then disconnect the
wire (flat type) (24 core).
(optical pick-up block will be destroyed without bridging.)
On the contrary at the installation, connect the
wire (flat type) (24 core) first, and then remove the bridge.
Note: For a soldering iron, use the one with a ground wire.
wire (flat type) (24 core).
(optical pick-up block will be destroyed without bridging.)
On the contrary at the installation, connect the
wire (flat type) (24 core) first, and then remove the bridge.
Note: For a soldering iron, use the one with a ground wire.
PRECAUTION WHEN REMOVING GOOD OPTICAL PICK-UP BLOCK
8
connector
Click on the first or last page to see other DAV-X1G / HCD-X1G service manuals if exist.