Read Sony DAV-X1G / HCD-X1G Service Manual online
8
HCD-X1G
POWER-AMP BOARD SERVICE POSITION
•
In checking the POWER-AMP board, prepare extension jig (Part No. J-2501-244-A: 1.00 mm Pitch, 21 cores, Length 300 mm).
MAIN board
(CN506)
(CN506)
POWER-AMP board
(CN301)
(CN301)
MAIN board
POWER-AMP board
Connect extension jig (J-2501-244-A) to the
MAIN board (CN506) and POWER-AMP board (CN301).
MAIN board (CN506) and POWER-AMP board (CN301).
Note: Remove the MAIN Board once, and then remove the POWER-AMP board.
After that, reinstall the MAIN Board and set this service position.
Reconnect the
power cord.
power cord.
Please place a sheet
for insulation.
for insulation.
KHM-310CAA
or
KHM-313CAA
1
two screws
(PTP3
(PTP3
×
8)
2
chassis cover
3
cover (CDM)
– bottom side –
HOW TO IDENTIFY OPTICAL PICK-UP BLOCK
There are two kinds of OPTICAL PICK-UP BLOCK in this set.
When replacing the OPTICAL PICK-UP BLOCK, make sure which OPTICAL PICK-UP BLOCK it is following the “How to Identify” in
the figure shown below.
When replacing the OPTICAL PICK-UP BLOCK, make sure which OPTICAL PICK-UP BLOCK it is following the “How to Identify” in
the figure shown below.
Click on the first or last page to see other DAV-X1G / HCD-X1G service manuals if exist.