Read Sharp XG-V10WE Handy Guide online
Lamp Replacement Procedure
Version 1.1
Issue 04/2006
Issue 04/2006
11
SHARP ELECTRONICS (UK) LTD
PROJECTOR TECHNICAL SUPPORT
TECHNICAL SERVICES GROUP
Removing and Installing the Lamp Unit
Note
•
Be sure to remove the lamp unit by the handle. Be sure not to touch the glass surface of
the lamp unit or the inside of the projector.
the lamp unit or the inside of the projector.
•
To avoid injury to yourself and damage to the lamp, be sure to carefully follow the steps
below.
below.
•
Do not loosen other screws except for the lamp unit cover and lamp unit. (Only the silver
screws are loosened).
screws are loosened).
•
Please refer to the installation manual included with the lamp unit.
1.
Press “OFF” on the projector to turn off the power.
•
Wait until the cooling fan stops.
Warning!
•
Do not remove the lamp(s) unit from the projector right after use.
The lamp will be very hot and may cause burn or injury.
The lamp will be very hot and may cause burn or injury.
2.
Disconnect the power cord.
•
Unplug the power cord from the AC socket.
•
Leave the lamp until it has fully cooled down (about 1 hour).
3.
Change the air filter.
•
Change the air filter whenever you install the lamp(s) unit.
Click on the first or last page to see other XG-V10WE service manuals if exist.