Read Sharp XG-MB70X (serv.man32) User Guide / Operation Manual online
change the language according to the procedure on
ues to run for about 90 seconds after the projector enters
the standby mode. This can cause damage due to rise in
internal temperature, as the cooling fan also stops.
AC socket on the rear of the projector.
connect any equipment that you use with the
projector. (See pages
• After the lamp indicator illuminates, the projec-
start projection. See page
Blinking green: The lamp is warming up
first minute after the lamp has been illuminated.
This is normal operation as the lamp's control
circuitry is stabilizing the lamp output charac-
teristics. This does not indicate malfunction.
take some time to illuminate.
that button again while the confir-
mation message is displayed, to
put the projector into standby
outlet after the cooling fan stops.
using the adjustment feet at the front and rear
of the projector when the screen is located
higher than the projector, the screen is inclined
or when the installation site is slightly inclined.
Install the projector so that it is as perpen-
dicular to the screen as possible.
height while pressing the
HEIGHT ADJUST button.
because the installation surface is diffi-
cult to slide. In this case, pull the pro-
jector back slightly and adjust its height.
HEIGHT ADJUST button of the
projector after its height has
been finely adjusted.
clination by turning the rear ad-
When “Auto Keystone” of the “Options2”
menu is set to “
cally to correct trapezoidal distortion.
When you want to adjust the automati-
cally corrected image, use the manual
keystone correction. (See page
without firmly holding the projector.
tween the adjustment foot and the projector.
degrees and the screen can also be set up
to an angle of approximately ±35 degrees
(when the resize mode is set to “NORMAL”
ing to that angle.
or from the bottom towards the screen at an
angle, the image becomes distorted trapezoidally.
The function for correcting trapezoidal distortion
is called Keystone Correction.
This projector is equipped with an “Auto Keystone
Correction” function that automatically corrects
any trapezoidal distortion within the projected im-
age. The correction is made automatically provided
the vertical incline or decline is within 12 degrees.
“Options2” menu to “OFF”.
Auto Keystone Correction function has been activated,
or when you want to make corrections without using
the Auto Keystone Correction function, you can make
corrections manually using the following procedure.
normally if there is an obstruction
between the auto focus sensor and
the screen, or if there is dirt or dust
on the auto focus sensor. Remove
any obstructions, dirt or dust.
or ZOOM buttons on the remote control, or
after you have pressed the ZOOM/FOCUS
button on the projector, you can display the
test pattern by pressing the ENTER button.
The test pattern is useful for making more
function that adjusts the focus automatically
when it is turned on. When you want to readjust
the focus after the Auto Focus function has been
activated, you can operate the Auto Focus func-
tion using the following procedure.
pattern disappears from the screen.
want to make fine adjustments.