Read Sharp PG-A20X Handy Guide online
Lamp Replacement Procedure
Version 1.5
Issue 04/2006
Issue 04/2006
11
SHARP ELECTRONICS (UK) LTD
PROJECTOR TECHNICAL SUPPORT
TECHNICAL SERVICES GROUP
Removing and Installing the Lamp Unit
Note
•
Be sure to remove the lamp unit by
the handle. Be sure not to touch
the glass surface of the lamp unit
or the inside of the projector.
the handle. Be sure not to touch
the glass surface of the lamp unit
or the inside of the projector.
•
To avoid injury to yourself and
damage to the lamp, be sure to
carefully follow the steps below.
damage to the lamp, be sure to
carefully follow the steps below.
•
Do not loosen other screws except
for the lamp unit cover and lamp
unit. (Only the silver screws are loosened).
for the lamp unit cover and lamp
unit. (Only the silver screws are loosened).
•
Please refer to the installation manual included with the lamp unit.
1.
Press “STANDBY” on the projector to turn off the power.
•
Wait until the cooling fan stops.
Warning!
•
Do not remove the lamp unit from the
projector right after use. The lamp will be
very hot and may cause burn or injury.
projector right after use. The lamp will be
very hot and may cause burn or injury.
2.
Disconnect the power cord.
•
Unplug the power cord from the AC socket.
•
Leave the lamp until it has fully cooled down (about 1
hour).
hour).
3.
Change the air filter.
•
Change the air filter whenever you install the lamp unit.
Click on the first or last page to see other PG-A20X service manuals if exist.