Read Sharp PG-A20X Handy Guide online
Lamp Replacement Procedure
Version 1.5
Issue 04/2006
Issue 04/2006
12
SHARP ELECTRONICS (UK) LTD
PROJECTOR TECHNICAL SUPPORT
TECHNICAL SERVICES GROUP
4.
Remove the filter/lamp unit cover.
•
Turn the projector over. Loosen the user service screw
(1) that secures the filter/ lamp unit cover. Pressing the
tab (2), remove the filter/lamp unit cover (3).
(1) that secures the filter/ lamp unit cover. Pressing the
tab (2), remove the filter/lamp unit cover (3).
5.
Remove the lamp unit.
•
Loosen the securing screws from the lamp
unit. Hold the lamp unit by the handle and pull
it in the direction of the arrow.
unit. Hold the lamp unit by the handle and pull
it in the direction of the arrow.
6.
Insert the new lamp unit.
•
Press the lamp unit firmly into the lamp unit
compartment. Fasten the securing screws.
compartment. Fasten the securing screws.
7.
Replace the filter/lamp unit cover.
•
Align the tab on the filter/lamp unit cover (1) and
place it while pressing the tab (2) to close it. Then
tighten the user service screw (3) to secure the filter/
lamp unit cover.
place it while pressing the tab (2) to close it. Then
tighten the user service screw (3) to secure the filter/
lamp unit cover.
Note
•
If the lamp unit and filter/lamp unit cover are not correctly installed, the power will not turn
on, even if the power cord is connected to the projector.
on, even if the power cord is connected to the projector.
Click on the first or last page to see other PG-A20X service manuals if exist.