PAS (serv.man3). New PageCounter terminal Administrators Guide. This is for the new replacement for the PCS100. - Sharp Copying Equipment Service Manual (repair manual). Page 13

 

PageCounter Administrator Guide Page 

11 

If the PageCounter will be used for copy control, have your copier technician connect 
the cable between the copier and the PageCounter using instructions from the copier 
manufacturer. 

If necessary, change the copier settings to use the key counter or vendor interface. 
These settings should disable the copier except when PageCounter has an active 
copying session. 

Use the power cable supplied with the terminal to connect the terminal power supply. 
When you connect the power to the PageCounter, the device begins its boot 
sequence. Once this sequence is complete, the terminal displays the idle mode screen. 

For information on configuring PageCounter devices in an Equitrac document 
accounting system, see the associated software Administrator Guide for details.  

To configure the terminal, see the next section Chapter 3:  Manager Mode. 

Once the device is configured, it is ready for use.