MX-PE10 FIERY (serv.man2). Service Manual - Sharp Copying Equipment Service Manual (repair manual). Page 101

Read Sharp MX-PE10 FIERY (serv.man2) Service Manual online

T
ROUBLESHOOTING
100
System performance (continued)
The Fiery Server hangs 
during the user software 
installation segment.
Possibly one of the following:
• The time and date need to be configured 
in the Fiery Server BIOS. (If the battery 
was removed from the Fiery Server 
motherboard during service and the time 
and date were not configured in Setup 
afterward, the Fiery Server will hang 
during the user software installation 
segment.)
• User Software DVD is corrupted
• The DVD drive is faulty
• The hard disk drive is faulty
1 Set the time and date in the BIOS:
• Power off the Fiery Server and remove the User Software 
DVD when it ejects.
• If not already connected, connect a keyboard and a monitor 
to the Fiery Server.
• Power on the Fiery Server and immediately press F2 
repeatedly to start the BIOS setup utility.
• Configure the time and date. 
(To navigate, use the tab key and the -/+ keys). 
• Save changes and exit (F10).
• When the Fiery Server reaches Idle, power off and then 
begin a full software installation again, starting with the 
System Software DVD (see 
page 83
).
2 If the problem persists, obtain another User Software DVD 
and begin software installation again starting with the 
System Software DVD (see 
page 83
). 
3 If the problem persists, you may need to replace the DVD 
drive (see 
page 78
).
If replacing the DVD drive does not correct the problem, 
reinstall the old DVD drive in the system.
4 If the problem persists, replace the hard disk drive (see 
page 70
).
If replacing the hard disk drive does not correct the 
problem, reinstall the old hard disk drive in the system.
Symptom
Possible cause
Suggested action 

Display

Click on the first or last page to see other MX-PE10 FIERY (serv.man2) service manuals if exist.

Random: