Read Sharp MX-M905 (serv.man7) User Guide / Operation Manual online
9
3) A test patch containing a column of 28 patches (3-30) is
printed.
Note:
When the printing of a test patch fails, the following
message appears: Printing test patch has failed. Use
8 1/2" X 11" or A4 paper for this adjustment. Tap the
[Execute] key to print the test patch.
4) Select the [5] or [32] keys for the number of adjustment
points.
Note:
If you selected the [5] key, visually check the five
points (4, 10, 16, 22, 29) on the test pattern. If you
selected the [32] key, visually check the density of the
28 points (3 to 30) on the test pattern.
5) Enter the desired values and tap the [Execute] key
to
start the adjustment.
◆
When the [5] key is selected in step 4):
Input range: [25] to [75]
Default: 50
◆
When the [32] key is selected in step 4):
Example of the Density Smoothing Adjustment (Visual
Adjustment) screen
Input range: [25] to [75]
Default: 50
Note:
If you want to darken a point after checking the test
pattern, increase the value. If you want to lighten a
point, decrease the value.
6) When the adjustment is completed, a completion
message appears and the adjustment result is printed.
Note:
When the printing of the adjustment result fails, the
following message appears: Printing adjustment
result has failed. Use 8 1/2" X 11" or A4 paper. Tap
the [Execute] key to print the adjustment result.
When the desired density is not achieved, tap the
[Readjust] key and repeat steps 2) to 6).
In 5-point adjustment, 5 points can be entered to
extrapolate and adjust all of the remaining 32 points.
In 32-point adjustment, each point can be adjusted.
If you selected the [32] key, the density of 1, 2, 31, and
32 cannot be checked on the test pattern. These values
are the setting range for A3W. If the density is not
uniform on A3W paper, print the test pattern on A3W
paper and enter the values of 1, 2, 31, and 32 as
needed.
When the desired density is achieved, tap the [Back]
key to return to the Laser Adjustment screen.
7) Make sure to perform [1.4.3 Standard Calibration]
under [Settings] if you wish not to erase the adjustment
values set by [1.4.1 Gray Balance Adjustment (for
Copy)] and [1.4.2 Gray Balance Adjustment (for Print)])
after this adjustment. Make sure to choose both the
copy and printer calibrations in the calibration.
R Side
F Side
R Side
F Side
Click on the first or last page to see other MX-M905 (serv.man7) service manuals if exist.