Read Sharp MX-M904 / MX-M1204 (serv.man9) Service Manual online
MX-M1204 MX-FN21/FN22 (FINISHER/SADDLE STITCH FINISHER) 18 – 6
G. Shunt cable connection
1)
Connect the shunt cable (Packed items No. 3) and the connec-
tion unit with the screw (Packed items No. 8 RS tight, M4 x 8).
tion unit with the screw (Packed items No. 8 RS tight, M4 x 8).
H. Height and tilt adjustment
MEMO: The specification of the height and the tilt adjustment are
as follows.
as follows.
Height: The difference of level between top surface of the adjacent
device is within
device is within
Tilt: The difference of clearance between upper and lower part of
the adjacent device is within
the adjacent device is within
1)
Open the front cover, and remove the wrench.
2)
Turn the fixing nut of the caster in the arrow direction with the
wrench to loosen it.
wrench to loosen it.
3)
Turn the adjustment nuts of the caster in the arrow direction
with the wrench to adjust the height. (When the adjustment nut
is turned one rotation, the finisher height is changed by about
1.75mm.)
with the wrench to adjust the height. (When the adjustment nut
is turned one rotation, the finisher height is changed by about
1.75mm.)
? To heighten the finisher height: Turn in direction [A].
? To lower the finisher height: Turn in direction [B].
MEMO: To adjust the height, use the four casters shown in the
figure below.
figure below.
1)
Turn the adjustment nut of the caster in the arrow direction
with the wrench to adjust the tilt.
with the wrench to adjust the tilt.
? To tilt the finisher to the right: Turn in direction [A].
? To tilt the finisher to the left: Turn in direction [B].
MEMO: To adjust the tilt, use the two casters shone in the fig-
ure below.
ure below.
[A]
[B]
[B]
[A]
[A]
[B]
[A]
[B]
Click on the first or last page to see other MX-M904 / MX-M1204 (serv.man9) service manuals if exist.