MX-M904, MX-M1204 (serv.man9). Installation Manual (Revised May 2017). - Sharp Copying Equipment Service Manual (repair manual). Page 123

MX-M1204  MX-FN21/FN22 (FINISHER/SADDLE STITCH FINISHER)  18 – 4

1)

Open the front cover of the finisher, pull out the hook of the
saddle stitcher unit until it stops.

2)

Attach the saddle stitcher unit supporting caster with the spring
washer screw so that the saddle stitcher unit accessory caster
(Packed items No.10) is on the floor.
(Attach with the two spring washer screws which are included
in the package.)

3)

Connect the connector of the saddle tray (Packed items No.9)
to the connector in the lower left side, and attach the saddle
tray with the two hooks.

1)

Fix the shunt cable unit (Packed items No.3) with the screw
(Packed items No. 8 RS tight, M4 x 8).

1)

Fix the latch receivers F/R (Packed items No.1) and the posi-
tioning pins (Packed items No.2) to the decurler unit with the
screws (Packed items No. 8 RS tight, M4 x 8).

2)

Fix the paper guide A (bundled with the decurler unit No.11)
and the protection sheet (bundled with the decurler unit No.14)
together with the screws (bundled with the decurler unit No.1).

MEMO: Temporarily attach the protection sheet to the decurler
unit with the duplex tape (back of the protection sheet), then fix
it with the screw.

1)

Fix the latch receivers F/R (Packed items No.1) and the posi-
tioning pins (Packed items No.2) to the decurler unit with the
screws (Packed items No. 8 RS tight, M4 x 8).

 

 

: ‘17/Apr.