Read Sharp MX-M364N / MX-565N (serv.man5) Service Manual online
MX-M565N MX-EB12N 25 – 1
MX-M565N
Service Manual
[25] MX-EB12N
1. Unpacking
A. Packed items check
Note for installing the mirroring kit
Before installing the mirroring kit, fully understand the descriptions
below and careful follow the instructions.
Prohibited items
When installing a mirroring kit newly, do not install a mirroring kit
which has been used.
When a mirroring kit which has been used is installed in new instal-
lation of the mirroring kit, the mirroring kit HDD will overwrite the
machine HDD which has been original installed, deleting the user
data and causing a freeze of the machine.
“A mirroring kit which has been used” includes one which was only
installed and conducted.
When removing the HDD after installing the mirroring kit, be sure to
remove the both HDD’s. If only one HDD is removed and rein-
stalled, the data on the both HDD's data may be out of synchroni-
zation.
When removing the HDD, first disconnect the HDD SATA connec-
tor of the MFP PWB. This procedure brings the machine into the
state where the both HDD's are disconnected from the machine
simultaneously.
Countermeasures
If a mirroring kit which has been used must be installed at any cost,
delete the mirroring information of the HDD before installing. (For
details, refer to “5. Deleting the HDD mirroring information”
described later.)
Before installing the mirroring kit, fully understand the descriptions
below and careful follow the instructions.
Prohibited items
When installing a mirroring kit newly, do not install a mirroring kit
which has been used.
When a mirroring kit which has been used is installed in new instal-
lation of the mirroring kit, the mirroring kit HDD will overwrite the
machine HDD which has been original installed, deleting the user
data and causing a freeze of the machine.
“A mirroring kit which has been used” includes one which was only
installed and conducted.
When removing the HDD after installing the mirroring kit, be sure to
remove the both HDD’s. If only one HDD is removed and rein-
stalled, the data on the both HDD's data may be out of synchroni-
zation.
When removing the HDD, first disconnect the HDD SATA connec-
tor of the MFP PWB. This procedure brings the machine into the
state where the both HDD's are disconnected from the machine
simultaneously.
Countermeasures
If a mirroring kit which has been used must be installed at any cost,
delete the mirroring information of the HDD before installing. (For
details, refer to “5. Deleting the HDD mirroring information”
described later.)
2. Installation
Before installation, be sure to turn both the operation and main
power switches off and disconnect the power plug from the power
outlet. Make double sure that the data lamp on the operation panel
does not light up or blink when performing installation.
power switches off and disconnect the power plug from the power
outlet. Make double sure that the data lamp on the operation panel
does not light up or blink when performing installation.
1. Left cabinet and shield plate removal
1) Remove the left cabinet.
2) Remove the shield plate.
2. Mirroring unit attachment
1) Before attachment of the mirroring kit, remove the protection
sheet from the mirroring kit.
No.
Name
Quantity
1
Mirroring unit
1
2
Screw
3
1
2
2
1
1
2
2
1
1
1
2
Click on the first or last page to see other MX-M364N / MX-565N (serv.man5) service manuals if exist.