MX-M364N, MX-565N (serv.man5). Installation Manual (Revised January2016). - Sharp Copying Equipment Service Manual (repair manual). Page 118

MX-M565N  MX-EB12N  25 – 3

1) Attach the shield plate.

2) Attach the left cabinet.

1) Turn on the main power switch and the operation panel power

switch.
Date copying from the standard HDD to the mirroring unit HDD
is started. It is called “Rebuilding.”

2) Check to confirm that the machine is booted. 

It takes about two hours to complete rebuilding. Do not turn off
the power during rebuilding. When, however, the power is
turned off during rebuilding, turn on the power again, and
rebuilding will be continued. During rebuilding, a message is
displayed to indicate the operation. A job can be performed
during rebuilding, though the job speed may be reduced.

1) Check to confirm that the mirroring kit active icon is displayed.
2) Use SIM62-20 to check to confirm that the HDD status is OK/

REBUILDING.

3) Perform copying and check to confirm that machine is normally

operating.

Be deleting the HDD mirroring information is necessary when dis-
continue use the mirroring kit.

RIB Buster software
The software is composed of the following two files. (They can be
downloaded from Tech DS Web site or Sharppcservice.com.)
-  RIB Buster{YYYYMMDD}.exe
-  Setup.ini

1)

-  USB cable
-  SATA connection cable
-  SATA connector
-  AC adapter
  (Support OS: Windows XP, Windows VISTA, Windows 7 (32/64bit)
  Windows PC

1)

Connect the target HDD to delete mirroring information with
the USB cable, SATA connection cable, SATA connector and
the AC adaptor as follows.

NOTE: When disconnect the cable from the HDD, be sure to dis-

connect the USB cable from the PC in advance.
If this precaution is ignored, the HDD may be damaged.

Mirroring kit installed

Mirroring kit/HDD trouble

Mirroring kit/Rebuilding