Read Sharp MX-M310 / MX-M310N (serv.man5) Service Manual online
MX-M260/M310/M260N/M310N MX-RP10 (Reversing single pass feeder) 2 - 2
6) Remove the filament tape located in the positions shown in the
illustration.
7) Connect the Centronics connector of the RSPF to the connector of
the copier and then tighten the screws of the connector.
8) Insert the intermediate tray all the way into the RSPF.
3. Adjustments
Insert the power plug of the copier to the outlet and turn on the
main switch of the copier.
main switch of the copier.
A. Adjust the RSPF white correction pixel
• Open the RSPF and execute SIM 63-7 to adjust the RSPF auto
white correction pixel.
1) Open the SPF unit and press the START key.
2) Shading position adjustment is performed. (Cannot interrupt)
If the simulation is executed with the SPF unit closed, an error is
resulted.
resulted.
3) [ ] indicates the order number of the pixel of the white sheet for
SPF exposure correction in the SPF position.
When the adjustment is completed normally, “COMPLETE” is dis-
played, and data are written into the EEPROM.
When the adjustment is completed normally, “COMPLETE” is dis-
played, and data are written into the EEPROM.
When the adjustment is completed abnormally, “ERROR” is dis-
played and data are not written into the EEPROM.
played and data are not written into the EEPROM.
∗ The SPF white correction start pixel = Displayed pixel position -34.
B. Adjust the document guide width (Sim53-6)
Caution: If this adjustment is not performed, the document size display
remains special.
1) With the document guide opened to the full, set A/3 (A/4) (WLT
(LT) in the inch system) paper and adjust the guide.
Press the start key.
Press the start key.
Filament tape
Filament tape
Filament tape
Screw
Screw
Intermediate tray
SIMULATION 63-7
SHADING POSITION ADJUSTMENT. PRESS START.
SIMULATION 63-7
SHADING POSITION ADJUSTMENT. EXECUTING...
SIMULATION 63-7
SHADING POSITION ADJUSTMENT. COMPLETE.
[160]
SIMULATION 63-7
SHADING POSITION ADJUSTMENT. ERROR.
[ 0]
SIMULATION 53-6
SPF TRAY ADJUSTMENT.
WLT PAPER SET, AND PRESS START KEY.
Click on the first or last page to see other MX-M310 / MX-M310N (serv.man5) service manuals if exist.