MX-M310, MX-M310N (serv.man5). Installation Manual. - Sharp Copying Equipment Service Manual (repair manual). Page 7

MX-M260/M310/M260N/M310N MX-RP10 (Reversing single pass feeder) 2 - 1

For unpacking, refer to the figure below.

• Parts included

1) Turn off the main switch of the copier and then remove the power

plug of the copier from the outlet.

2) Lift the platen cover and remove it from the copier.

3) Remove the right and left glass holders and remove the document

glass.
Remove the two screws (M3 x 8) of the left glass holder and the
three screws (M3 x 8) of the right glass holder.

4) Insert the RSPF glass holder to the document glass.

Then, attach the document glass to the copier, fix the left glass
holder that has been removed in step 3 using two screws (M3 x 8),
and fix the RSPF glass using three screws (M3 x 8).

5) Insert the hinge portion of the RSPF to the mounting portion of the

copier by holding the RSPF at an angle toward the rear side.

RSPF glass cover

Intermediate tray

Screws (M3 x 8)

Screws (M3 x 8)

Left glass 
holder

Document glass

Right glass holder

Screws (M3 x 8)

Screws (M3 x 8)

Left glass 
holder

Document glass

RSPF glass holder

Hinge

Hinge