MX-FX11 (serv.man5). Revised December 2010 - Sharp Copying Equipment Service Manual (repair manual). Page 14

MX-FX11  FAX SOFTWARE SWITCH  2 – 10

36

6

Print

Printing of transmitted 
document contents at 
times of F code 
communication 
<FAX only>

Setting to determine whether or not to print part of the transmitted document on 
the communication results sheet at times of F code communication. However, 
only when the "Document contents printing at times of transmission" setting is 
valid.
"0": Do not print
"1": Print
The "Document contents printing (results sheet) at times of transmission" 
setting takes priority.

7

Print

Document content print 
when sending (PC-Fax 
(Internet Fax) report 
table)

Setting to print images or not on the report table when sending PC-Fax 
(Internet Fax).
"0": Not print
"1": Print
When the system setting is set so that images are added in the communication 
report table, if the destination is a PC-Fax (Internet Fax), the document 
contents are printed by this setting.

8

Not used

37

1, 2

Function

Protocol monitor

Setting to determine whether or not the protocol monitor (recognized by the 
FAX) for 1 communication is printed.
"00": No (do not print)
"01": No (do not print)
"10": Print (always)
"11": Only at times of error (print)
When a new communication occurs before the protocol monitor is printed, 
delete the old protocol data (overwrite).

3

Function

Determination of sub-
scan length 
(determination setting 
when selecting the 
page)

Setting to determine whether to give priority to width or length when selecting 
the optimum sheet when printing received data.
"0": Priority to data length
"1": Priority to data width

4

Print

Paper selection when 
reception printing 
(LTR/A4)

Used to set whether LTR is confirmed first of all in selection of paper for 
reception printing or paper that provides smaller reduction rate of A4 and LTR is 
selected.
"0": Priority on LTR/A4 reduction rate
"1": Priority on LTR

5

Not used

6

Function

Valid/Invalid setting of 
FAX A4, 8.5 x 11 
threshold

When printing received FAX data with A4 and 8.5 x 11 paper in the tray, this 
setting determines whether to make threshold values in paper selection valid or 
invalid. If made valid, it becomes easier to select letters.
"0": Valid
"1": Invalid
When printing received Internet FAX data, conduct setting using the separate 
SW (Valid/Invalid setting of Internet FAX A4, 8.5 x 11 threshold).

7

Reception

Setting of the reception 
width of 11x17 sheet

This sets the receivable document width in cases where "11 x 17 sheet" is 
selected as the FAX printing paper.
"0": A3 width (A3, B4, A4)
"1": B4 width (B4, A4)

8

Communication

Data line parity check 
(Between ICU - 
FAXBOX)

The parity on the data line between the ICU and the FAXBOX is checked. 
(Supporting the E7-06 problem)
"0": Parity is checked.
"1": Parity is not checked.

38

1-4

Function

Magnification setting in 
automatic reduction

Setting to determine the page length for reduced printing of documents 
received when automatic reduced printing is set at permitted.
Percentage threshold that can be reduced (excluding reduction between fixed 
page sizes)
Setting can be made over the range of 85% to 100% in 1% increments by 
binary inputting (N x 1% + 85%).
The initial value of 90% is reverted to if a value outside of the setting range is 
set.

5

Print

Rotated printing

Setting to determine whether or not to rotate and output received data when 
this is possible at times of receiving and printing FAX and Internet FAX data.
"0": Permitted (rotate and print)
"1": Prohibited (do not rotate and print)

6

Print

Designation of rotation 
direction when printing 
on both sides and the 
rear side.

Setting to determine whether to adopt vertical binding or horizontal binding 
when printing on both sides.
When horizontal binding is selected, the header position on both sides (front 
and rear) is printed in the same direction.
When vertical binding is selected, since the image rotates by 180 degrees, the 
header position is reversed. 
"0": Horizontal binding
"1": Vertical binding

7

Function

Setting of received 
document output when 
receiving

Setting to determine whether to output data received in FAX, Internet FAX 
communications en masse or to output 1 page at a time as it is received.
"0": Save and output en masse following completion of reception
"1": Output 1 page at a time