MX-FX11 (serv.man5). Revised December 2010 - Sharp Copying Equipment Service Manual (repair manual). Page 16

MX-FX11  FAX SOFTWARE SWITCH  2 – 12

40

1

Not used

2

Reception

Setting to refuse 
reception at times of 
manual reception 
(FAX) 

Setting to determine whether or not to validate refusal of reception of 
designated numbers. However, only at times of manual reception.
"0": Receipt of designated number is not refused (invalid)
"1": Receipt of designated number is refused (valid)
However, at times of automatic reception, perform using a separate SW 
(Setting to refuse reception at times of automatic reception).
Only valid in cases where the "Specified number reception Enable/Disable 
setting (FAX)" is refused.

3

Reception

TSI judgment setting 
(no signal or all space) 
when refusing 
reception from 
designated numbers

Setting to determine whether to refuse or permit reception when there are no 
TSI signals from the other party’s machine or signals are all spaced in cases 
where the refusal of designated number reception set by system setting is 
valid.
"0": Reception will be permitted.
"1": Reception will be refused.
Only valid in cases where the "Specified number reception Enable/Disable 
setting (FAX)" is refused.

4

Reception

TSI judgment setting 
(No numbers and no 
space can be used.) 
when refusing 
reception from 
designated numbers

Setting to determine whether to refuse or permit reception when TSI signals 
from the other party’s machine are no numbers and no space can be used 
reception set by system setting is valid.
"0": Reception will be permitted.
"1": Reception will be refused.
Only valid in cases where the "Specified number reception Enable/Disable 
setting (FAX)" is refused.

5

Communication

PIN code 
correspondence

Setting to determine whether or not to limit FAX dial number display to 16 digits. 
When this is set to "1: Correspond," FAX number display based on the resend 
key and the other party’s number on the job status completion screen are 
displayed from the start to the 16th digit. When this SW is set as valid, it is also 
reflected in report contents.
"0": Do not correspond
"1": Correspond
FAX address display limit (displayed up to the 16th digit from the front)

6-8

Not used

41

1

Not used

2

Function

Reversion from the 
energy saving state 
(excluding preheat) 
when the external 
telephone is off-hook

Setting to determine whether or not to revert from energy saving with the 
external telephone off the hook in the energy saving state (excluding preheat).
"0": Do not revert
"1": Revert

3

Not used

4

Function

Scope of line sound 
monitor

Setting to determine the scope of monitoring when the line monitor function is 
used
When "Until NSF signal send/receive" is set, monitoring is conducted until the 
DCS or NSF signal is received. When "All" is set, everything is monitored until 
the line is disconnected.
"0": Until NSF signal send/receive
"1": All
Setting of line monitor sound ON/OFF is done by a separate SW.

5

Call arrival

V150V24 detection 
setting

Setting of detection when non-ringing setting is received.
"0": 24V detection
"1": 150V detection

6-8

Not used

42

-

89

1-8

Not used