MX-FNX10. MX-FN10 Service Manual (Complete) - Sharp Copying Equipment Service Manual (repair manual). Page 14

MX-FN10  OPERATIONAL DESCRIPTION  5 – 1

MX-FN10

Service Manual

 

1)

The transport motor and the transport motor 2 are driven at the
paper exit speed of the main unit, and paper is discharged
from the main unit.
At that time, the paper exit roller goes into the nip state. 

2)

The inlet port sensor turns on, and the paper rear edge
reaches the specified position. Then the speed of the transport
motor and the transport motor 2 is changed to the inside-the-
main unit speed. 

3)

The inlet port sensor turns OFF and the paper rear edge
reaches the specified position. Then the speed of the transport
motor is changed to the paper exit speed of the main unit, and
the speed of the transport motor 2 is changed to the stack tray
paper exit speed. 

4)

When the paper rear edge goes out of the paper exit roller, the
speed of the transport motor 2 is changed to the paper exit
speed of the main unit. 

1)

The transport motor and the transport motor 2 are driven at the
paper exit speed of the main unit, and paper is discharged
from the main unit.

2)

The inlet port sensor turns on, and the paper rear edge
reaches the specified position. Then the speed of the transport
motor and the transport motor 2 is changed to the inside-the-
main unit speed. 

3)

The inlet port sensor turns OFF and the paper rear edge
reaches the specified position. Then the speed of the transport
motor is changed to the paper exit speed of the main unit.

4)

When the paper rear edge reaches the reverse position for
storing to the process tray, the transport motor 2 is temporarily
stopped. Then the transport motor 2 reverses to store paper in
the process tray. 

5)

When paper is stored in the process tray, the alignment plate
reciprocates to align paper.