MX-FNX10. MX-FN10 Service Manual (Complete) - Sharp Copying Equipment Service Manual (repair manual). Page 17

MX-FN10  OPERATIONAL DESCRIPTION  5 – 4

3)

The inlet port sensor turns OFF and the paper rear edge
reaches the specified position. Then the speed of the transport
motor is changed to the paper exit speed of the main unit. 

4)

When the paper rear edge reaches the reverse position for
storing to the process tray, the transport motor 2 is temporarily
stopped. Then the transport motor 2 reverses to store paper in
the process tray. 

5)

When paper is stored in the process tray, the alignment plate
reciprocates to align paper.

6)

Reception of paper in the process tray is repeated until the
specified number of sheet for a bundle is stacked. (1 - 5)

7)

When all the sheets of a bundle are discharged to the process
tray, stapling is performed. 

8)

After stapling, the paper bundle is discharged to the stack tray
by the gripper. 

1)

The transport motor and the transport motor 2 are driven at the
paper exit speed of the main unit, and paper is discharged
from the main unit.

2)

The inlet port sensor turns on, and the paper reaches the
specified position. Then the speed of the transport motor and
the transport motor 2 is changed to the inside-the-main unit
speed. 

3)

The inlet port sensor turns OFF and the paper rear edge
reaches the specified position. Then the speed of the transport
motor is changed to the paper exit speed of the main unit. 

4)

When the paper rear edge reaches the reverse position for
storing to the saddle process tray, the transport motor 2 is tem-
porarily stopped. Then the transport motor 2 reverses to store
paper in the saddle process tray.