MX-FNX10 (serv.man38). IMPROVEMENT OF SADDLE FINISHER (MX-FN10) - Sharp Copying Equipment Technical Bulletin (repair manual). Page 15

22. Raise the semicircular gear a little and turn the gear so that the center of the 2 slits of the semicircular gear 

comes to the center of the sensor on the rear side. 

(Please make sure that the semicircular side of the semicircular gear faces toward the tray side.) 
(Please make the slits and the sides of the sensor parallel.) 
(Please be careful not to drop the semicircular gear.) 
 

 
23. When the adjustment is finished, lower the semicircular gear to engage it with the white gear, and attach the clip. 

(Please be careful not to drop the clip using long-nose pliers and so on.) 

 
24. Attach the harness duct removed in the procedure 13, and attach the connector. 
 
25. Return the Cover-TR-Wall and the exterior. 
 

Note 1 

Please be careful when you return the Cover-TR-Wall, because there are parts for attachment (2 parts at the 
backside bottom and 3 parts at the top), to make sure it is attached correctly without a gap. 
 

 

Sharp Electronics (UK) Ltd., Technical Services Group

CCE-621