Read Sharp MX-FNX10 (serv.man38) Technical Bulletin online
16. Raise the gears of the joint metal plate and the saddle stitch STP to separate them from the joint gears.
*You can adjust the phase without removing the metal plate by moving the gears upward as above.
17. Move the gripper unit to the front side while the joint gear is kept apart.
Place the gripper unit against the metal plate as indicated by the box in the picture below.
Open the gripper before moving the gripper unit by turning the square shaft shown in the picbure below
clockwise with a flat screwdriver.
(If you move it without opening the gripper, it may hit the U-shaped metal plate.
Open the gripper before moving the gripper unit by turning the square shaft shown in the picbure below
clockwise with a flat screwdriver.
(If you move it without opening the gripper, it may hit the U-shaped metal plate.
18. Move the saddle stitch STP to the front side while the joint gear is kept apart.
Move the side stitch STP to the position adjacent to the metal plate as shown by the box in the picture below.
It may be pushed back from the metal plate by the spring, but keep it in the state it touches the front side, lower
the gear of the side stitch STP turning it counterclockwise, and engage it with the joint gear.
It may be pushed back from the metal plate by the spring, but keep it in the state it touches the front side, lower
the gear of the side stitch STP turning it counterclockwise, and engage it with the joint gear.
Sharp Electronics (UK) Ltd., Technical Services Group
CCE-621
Click on the first or last page to see other MX-FNX10 (serv.man38) service manuals if exist.